Q: Where is the water pump control relay located on 06 bmw 325i

asked by on

Where is the water pump control relay located on 06 bmw 325i

The water pump control module is mounted in the left rear of the engine compartment. The system does not have a relay but a control module.

Was this answer helpful?
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details
  1. Home
  2. Questions
  3. Where is the water pump control relay located on 06 bmw 325i

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: I have a 2001 BMW 325i. It overheated, engine shut down. When cooled down (24 hours), while water poured in the reservoir I could

I'm not clear on where you see your leak, but if it is in the radiator tank itself, that will mean you at least need a radiator. If the car ran hot until it shut off, there may have been...

Q: Air vents cannot turn off on 2006 BMW 530xi

Hello. The issue you are experiencing with your 2006 BMW 530xi is likely from a faulty blower motor, faulty blower motor resistor or a faulty blower motor control switch. If left on for too long, yes, it will drain your...

Q: Car won't start - 2006 BMW 325i

Hi there. If the engine is not cranking, then the issue can be a number of things. I usually start by checking for power at the starter when trying to crank it over. If there is no power there, then...

Related articles

How Long Does a Distributor O Ring Last?
The distributor is part of the ignition system in your vehicle and its purpose is to route high voltage from the ignition coil to the spark plug. The spark plug then...
How Long Does a Heater Control Valve Last?
Keeping the right amount of coolant in a car is essential in keeping the engine at the right temperature. Failing to have the right amount of coolant or even bad elements...
P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...