Q: When I press my brake pedal I hear a whistle sound

asked by on June 22, 2017

When I press my brake pedal down I hear a whistle sound The brake pads are new it's a Ford edge 2011

My car has 6500 miles.

Your brake master cylinder is leaking vacuum or your vacuum check valve at the vacuum connection is leaking or noisey. Have these two things checked to isolate where the noise is coming from and replace noisey part.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing


Experienced Mechanic?

Earn up to $65/hr

What others are asking

Brakes lock up during driving, if the car is stopped fast

Hello. If the vehicle has anti-lock brakes, then it should not lock up like this. This will only occur if there is a sensor problem with the vehicle. I would start by installing a scan tool that can read the...

I have a 2011 6 cylinder Kia Sorento. Just changed all the spark plugs to achsah go. While driving today my car stopped accelerati

Slow acceleration has a variety of causes. Fuel injectors can become clogged over time as the tiny passages become clogged. When an injector is clogged it can degrade the performance of the vehicle and the car may accelerate slowly or...

Missing IAC valve vacuum line.

The IAC (Idle Air Control) valve is required to have a vacuum line on it to work the engine properly. The line from the carbon box filter is supposed to be hooked to it, but it may be damaged. Take...

CAR completely dead, lights on but are dim, lost power steering, and power windows, ABS LIGHT AND BATTERY LIGHT ARE ON,

There are several possibilities, all involving the vehicle electrical system. I would suggest first measuring charging system output. If charging system output is normal, and the battery is new and fully charged, and yet the lights are dim and the...

When changing the engine mount, do you have to change out the brackets one at a time?

Hello. If the engine mounts are bad then they need to be replaced. Many times the vehicle will only need one mount if the issue was found early enough. If it was put off for a long time then that...

No air blowing and compressor not coming on

You may have two different problems or the a/c control switch went bad. The blower since it has power then the blower resistor or blower switch may be bad. For the compressor not coming on you would need to have...

both back doors wont open

Hello, thank you for writing in. Due to the fact both doors are having this issue suddenly, it is likely an electrical issue. The doors are likely locked, either due to the child-safety lock or the standard lock you have...

What caused my wheel speed sensor failure?

A wheel speed sensor is the most common failure in the ABS system. The reason your engine management and traction control light are also on is because those systems "borrow" wheel speed information from the ABS system. The reason the...

My car jerks at 45-50 mph during acceleration, and then it smooths out.

Hi There, The jerking reaction you are describing may indicate a dirty or failing mass air flow sensor which is a unit that monitors air intake and relays this info to the ECM which then makes adjustments to the fuel...

Related articles

A Buyer’s Guide to the 2012 Ford F-450
The The 2012 Ford F-450 is a serious truck with major towing and hauling capacity. What it lacks in gas mileage, it more than makes up for in durability, suspension, power, and torque. Plus, with a six-speed shiftable automatic transmission,...
What are the Types of Brake Fluid?
Dot 3, Dot 4, and Dot 5.1 brake fluids are most common in modern vehicles. They differ in wet and dry boiling points.
How Do I Know If My Brakes Need Replacing?
Certain symptoms tell you when to replace car brakes. The Brake Warning Light and squeaky brakes are common signs of worn out brake pads or rotors.