Q: What could be wrong with my car if the wheel is hard to turn while driving? I put power steering fluid in the car.

The intake gasket on these engines are known to fail and you will get a large amount of unmetered air. A smoke test will reveal if the gaskets are leaking. If the intake gasket is leaking, the repair is extensive....

Hello. If they replaced your piston rings and the problem has persisted, then it is likely that the problem was not related to the piston rings. Most fuel issues are related to engine performance or fuel system problems. A tune...

Hello. I usually start by checking the battery (https://www.yourmechanic.com/services/battery-is-dead-inspection). If it is low enough these other systems will work but there will not be enough power to engage the starter. If the battery is fine then most of the time...

Hello there, misfires in cylinder 1 of your 2010 Acura TSX can be due to a variety of causes. The spark plug and coil are the most likely culprits and you have done well in replacing them first. There are...

Hello and thank you for your question. Toyota vehicles have a self test built within the computer systems. When you put the key in the ignition and turn on the key to the On position or Accessory position, the engine...

Based on the symptoms you described it seems as if your fan clutch (https://www.yourmechanic.com/services/fan-clutch-replacement) or water pump (https://www.yourmechanic.com/services/water-pump-replacement) may be having an issue. I would recommend having your cooling system pressure tested by a qualified professional to determine the exact...

Hi and thanks for contacting YourMechanic. Check to see what issues you are encountering. If you had to replace the brake booster, then you are implying that the brake pedal is hard. If you have replaced the brake booster and...

In your circumstance, two possible causes of no cylinder compression are a broken timing belt or a faulty head gasket. Replacing a timing belt is a fairly common repair. Replacing a head gasket is somewhat involved, and will have more...

Load test the vehicle battery (https://www.yourmechanic.com/services/battery-is-dead-inspection). Sometimes when a battery is on the verge of failure, the resulting voltage drop "fools" the vehicle alarm system as this voltage drop is interpreted by the computer as tampering. If the battery passes...