Q: What are the symptoms of a drive shaft going out on a 01 Subaru outback

I would need more information to determine the problem. If you hear a clicking noise but the engine wont turn over, then your battery may not have enough charge or may have a bad connection. Test the battery, if the...

Yes, without hearing the noises or being able to inspect the vehicle it is hard to determine with any accuracy what the items could be. You can have a certified mechanic, like one from YourMechanic, and schedule for someone to...

The first thing to do is to have the fuel cap replaced (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-fuel-filler-cap). The cap may be overtightened, causing gas tank venting to be blocked. If this gets blocked then the fuel tank can go into a vacuum and cause...

The first step is to check the level of the oil. Assuming it's full, and there are no leaks on the system, it could be the pump or the sensor. The easiest way, despite that you need a special tool,...

Hi there. Usually the gaskets between the transmission and the transfer case are known as the transfer case gasket or the transfer case adapter gasket. The gasket may be listed as the type of transfer case and then followed by...

This is likely a problem with something on your starter called a starter solenoid. The starter solenoid is located on the starter and has internal electrical contacts that transmit electricity to the starter. As electricity is supplied to the starter...

Hello - your failure scenario description suggests a blown headgasket, especially with a history of overheating (https://www.yourmechanic.com/question/overheating-problem-with-my-car). I would have the compression checked first, and suspect it will be low on most cylinders. It is also possible that the timing...

The manufacturer's warranty on the 2015 Chrysler is 3 years/36,000 miles and 5 years/100,000 miles on the powertrain. You should determine whether you have warranty coverage of this issue to reduce, or even eliminate, your potential repair cost. Any suspected...

The part that is covering the oxygen sensor is the heat shield on the exhaust manifold. You will have to remove the heat shield first to get the O2 sensor off. If you need further assistance with removing the heat...