Q: Water pump may be broken

asked by on February 05, 2016

I think the water pump either blew the gasket, seal, or hose.

Oil/Fluid Leak Inspection $79.99 - $89.99 Get a Quote

Hi. It sounds like your water pump, or perhaps another part of the vehicle, may be leaking. It would be best to have a professional technician, such as one from YourMechanic, pressure test the vehicle to determine where the leak is coming from, so that the appropriate repair can be made.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

What others are asking

Do you do rear axle bearings and seals? 2005 Ford Crown Victoria

Hello, unfortunately, rear axle bearing replacement is not a service YourMechanic offers at this time. However we can provide rear axle seal and brake service for your Crown Vic. Thanks for thinking of us! Sent to CS rear axle...

How do I unlock the seat belt?

Occasionally the seat belt will lock, making it hard for you to move, or buckle the belt. When this happens, allow the belt to retract fully, wait a few seconds, and then pull the belt out very slowly and smoothly....

How do you scan the GEM module in a 1996 Ford Explorer?

The GEM module can only be scanned using a scanner capable of accessing the GEM module through the OBD2 data link. The scanners that the Ford dealer uses can access the module. There are aftermarket scanners on the market than...

Ran out of gas put gas in it but not getting to carburetor maybe it's the fuel filter

You should first try to replace the fuel filter and then with fuel line disconnected test to see if the fuel pump is pumping close to 5 psi of fuel pressure and is pumping fuel. When the vehicle ran out...

Where is the location of the cabin air filter on a 2002 F-250 P/U, 2-wheel drive, Diesel 7.3?

For some reason Ford used three different evaporator case designs in the trucks this year. The filter will be in one of these three locations. Look behind the glove box and there is a cover on case and filter is...

P0301 code, steady misfire.

Hey there. In order to check the cylinder for spark you have to remove the coil and insert a spark tester into the coil after reconnecting it. Then you can check to see if it has spark. The injector will...

Stripped water pump bolt/screw

Unfortunately, the stripped bolt in your water pump housing may very well have backed out causing the seal on the water pump gasket to be compromised resulting in the pump leaking coolant which may cause the motor to overheat. Depending...

Car will not start and there is no spark. Could it be ECM?

Hi there. Diagnoses needs to be performed to identify the cause of a no start condition. As you already know, replacing components can be expensive and time consuming without resolution. Checking the fuses in the power distribution center would be...

What is the recommended tire inflation pressure?

It is very important to always have your tires properly inflated. The proper tire inflation pressure is located on the Safety Compliance Certification Label or the Tire label, which are on the B-Pillar, near the door latch, or on the...

Related articles

The Best Used Cars to Buy For a Graduation Gift
Your Your little bundle of joy has grown up and on the cusp of entering adulthood. Graduating is a milestone, and you want to reward their hard work and show how proud you are. Buying a used car is a...
Symptoms of a Bad or Failing Water Pump
Common signs include coolant leaks at the front-center of the car, loose water pump pulley, overheating engine, and steam coming from the radiator.
How to Use Engine Block Sealer to Repair a Head Gasket Leak
Head gasket leaks occur when engines overheat and can be costly to repair. Engine block sealer can be a quick and easy alternative for minor cases.