Second Opinion] My 2004 Toyota [Camry](/topics-camry/) ha...

Second Opinion] My 2004 Toyota [Camry](/topics-camry/) has about 280,000 miles on it. I recently was running low on oil but it was not quite do for an oil change. so I put in a couple quarts of oil and some [engine](/topics-engine...

Second Opinion] My 2004 Toyota [Camry](/topics-camry/) has about 280,000 miles on it. I recently was running low on oil but it was not quite do for an oil change. so I put in a couple quarts of oil and some [engine](/topics-engine-toyota/) cleaner In it thinking that by the time the engine cleaner circulated it would B time for an oil change. I have never used the engine cleaner before. After a few days and maintenance light came on. The car stalled a few times while sitting at a light. And then today while I was driving it it made one loud pop. What should I be watching for? Mechanic's Assistant: Where exactly do you think the noise is coming from? And how long has this been going on? I'm guessing the engine. The loud pop is only happened this time Mechanic's Assistant: Are you fixing your Camry yourself? What have you tried so far? Nothing it just happened

Automotive Expert
**Bradley Jordan** **Nissan**** , Subaru, and Infiniti Master Technician** **ASE Master Tech All Makes** **Factory training,Subaru,Toyota,Isuzu and Kia** **Let me take a moment to review your request.** **_You may be prompted for a phone call, this is optional as the request is automatic_** Is the engine still running?

I am guessing that the maintenance light came on because it's near due for an oil change
Automotive Expert
The directions on the engine cleaner you run it for 15 minutes at idle fully warmed up, you are not supposed to drive with the cleaner in there. the maint light is a mileage reminder. you need to change the oil and filter and get the cleaner out of the car.

It's said that I should leave it in for the full tank of gas
Automotive Expert
did you add a fuel cleaner or to the engine oil? Either way, I would start with a oil and filter change,
Automotive Expert
**If you need more help, just follow up with your question and I can give you more information.** **it was my pleasure to help you today, exceptional service is my goal and I hope I provided** **Exceptional service for you today. Good luck with your repairs and have a wonderful day** **Thankyou** **Bradley**

thank you
Automotive Expert

What others are asking

Headlights brighten and then dim while driving over bumps
Often headlights seem to get brighter or dimmer when there is a bad connection or a failing switch. Since a bad connection can be inside the light bulb itself, I always start by inspecting the bulbs first to see if...
Hi I have this dtc:P0698 description (failure of wiring and connection. failure of spark plug control module) engin no start
Hi there. Typically this is a failure in the ignition control circuit. Most of the time it is a wiring failure going to the ignition coils such as a bad ground connection. It can also be caused by a failure...
Oil pressure switch was replaced but the Check Engine Light is still on.
Hello there, a few different things will cause your 2011 Honda Pilot to still have the Check Engine Light on after the oil pressure switch ( was replaced. The most common cause would be the code not being cleared after...
Idle issue
The low idle may be contributing to the flickering of the lights in the dash due to low charging output by the alternator as a result of the low engine idle. The low idle may be a result of a...
I need to know where the fuel line kill switch is located
Hello. There is no fuel line kill switch for your particular vehicle. There is a fuel pump fuse which can act as a fuel line kill switch. It is located in the rear compartment fuse box. The rear compartment fuse...
I have a Broken fuel door latch and it doesn't look good 
To repair the fuel door latch, open the trunk up and remove the side covering panel where the fuel door would be located at. There you will see the the fuel door latch with a harness on it. Remove the...