Q: Throwout bearing fork problem

asked by on March 28, 2016

I have an issue with the throwout bearing fork. It's not allowing the clutch to engage.

Hi, if there is no fluid leaking from under the car then the linkage has an issue somewhere. All of the components in the clutch linkange are susceptible to wear and tear over the years and should be inspected. A certified technician, such as one from YourMechanic, would be able take a look at the linkages and cable to make sure there is no damage.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing


Experienced Mechanic?

Earn up to $70/hr

What others are asking

My breaks sometimes stop car completely and sometimes it doesn't what would cause this?
Usually a person describes such an experience as more force than usual is needed to stop the car. I am not exactly sure what you are experiencing here, so I will address a few things. Speed and weight of your...
Hello Jim.. I am replacing an alternator in a Scion xb and have everything covered except I can find any info on the belt tensione
If you are planning to replace your alternator (https://www.yourmechanic.com/services/alternator-replacement) and need to release the tension on the belt for removal, I would recommend starting by removing the front right wheel. Then I would remove the splash guard behind the wheel...
I have a 2001 5.4 Ford F150. The oil pressure light & gauge is on.
Hello there, many common faults will result in your oil pressure gauge reading only after a few minutes and the Oil Pressure Light being on in your 2001 Ford F-150. The most common fault that would cause this is low...
Water pump replacement after coming loose?
Water pumps do NOT get loose on an engine excepting an unusual circumstance where the pump was improperly installed. So, the mechanic might be referring, in your circumstance, to a seized water pump or a situation where the water pump...
When air comes into vehicle so I can have the defroster on - it sucks exhaust fumes from other vehicles to inside my car.
Hi there. All vehicles are set up to take the air from outside and have the air conditioning on to make the defroster work. There is nothing you can do to change the defrost settings.
Where is tranmetion dipstick on Chev HHR
This would depend on if you have an automatic or a manual transmission in your HHR. If you have a manual transmission, there will be no dipstick as it is only servicable from underneath the vehicle. If you have an...
2002 GMC Envoy message displayed on message board, turn engine off now. What does this mean?
Hi there. The message could have came on for something that may have been active on the engine or transmission. If the light comes on again, then the computer (ECM) should store the events and you could have them read...
Vauxhall insignia se nav 2.0 cdti - interference or non interference engine
Hi there. Yes the engine is an interference design. This means that if the timing belt breaks the pistons will contact the valve train when not in time. If the belt has broken, I recommend testing the cylinder head and...
No power stalling and very hard to accelerate because it surges and sputters
Hi Jacob. Diagnosing an issue like this is best when you understand all of the possible sources of an OBD-II trouble code. When the signal to and from the camshaft position sensor and the PCM is broken, the ignition spark...

Related articles

How Can I Tell If My Clutch Is Slipping?
For some drivers, shifting a manual transmission is second nature. Others prefer to rely on automatic transmissions. Drivers of automatic vehicles don’t have...
How Long Does a Clutch Cable Adjuster Last?
The The clutch cable adjust is attached to the clutch cable and helps to keep tension so the clutch pad does not slip while the vehicle is operating. The clutch itself is located between the gearbox and the engine. The...
Symptoms of a Bad or Failing Flexible Clutch Hose
Common signs include difficulty shifting, low clutch fluid, and feeling no resistance at the clutch pedal.