Q: The turn indicators are not blinking, they just turn on. And the hazard lights are not working at all..

asked by on November 02, 2016

Hi, My 2006 Mazda 6 turn indicators not blinking, they just turn on. And the hazard (double indicators) not working at all.. Can it be the flasher or the bcm?
My car has an automatic transmission.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing


Experienced Mechanic?

Earn up to $70/hr

What others are asking

Brake light comes on.
Hi, it sounds like the brake light switch needs replacing (https://www.yourmechanic.com/services/brake-light-bulb-replacement) under the dash. I would have a technician such as one from YourMechanic replace it for you.
Door will not unlock
Hi. If the door stopped working after it was shut hard, then the door lock actuator rod may have come off of the actuator or the actuator failed. It can also be due to the main switch assembly failing. Both...
smashed bumper in front and hood alittle.
Have you noticed any symptoms so far while driving it? It could be unsafe depending on how severe it is, but I would really have to visually see it and check under the hood to make the call. You can...
Wheel studs breaking off when changing tire
Hey there: Thanks for writing in to YourMechanic.com. Breaking a wheel stud is commonly not caused by the way you're removing them, or the tool you are using. Lug nuts are supposed to go onto a stud smoothly, and come...
I felt a jolt while driving - could it be a transmission issue?
Hi. This is a good indication that the transmission has overheated and damaged a lot of the internal parts of the transmission. This could have been caused by low transmission fluid or extremely dirty transmission fluid causing a cloth in...
Tring to find out exactly what wrong.
Hello, thank you for writing in. The first thing to consider is the age and mileage on the vehicle. There could be a significant amount of work that needs to be done. With that being said, you will either have...
My heater makes a really loud noise when its on.
The level of refrigerant in the air conditioning system would not affect the noise level of the blower motor. If you replaced the motor with an aftermarket (non OEM) motor that could create an issue in terms of the quality...
oil pressure light blinking when start,My car is toyota 86,can advise me?
Hello, thank you for writing in. The moment you put your key in the ignition, or get into the vehicle with a keyless starting system, the vehicle begins to run tests on its monitored components. The oil pressure system is...
There is a slight wobble at speeds between 50 and 70 mph and I'm not sure what is causing it.
Hi there. It seems as if you have a few possible issues going on with your Jeep. First, if you have a bent wheel, the tire and wheel combination will never balance correctly; as weight distribution on the tire and...

Related articles

A Buyer’s Guide to the 2012 Mazda 5
If If you’re looking for a vehicle that isn’t quite a minivan yet is bigger than a wagon, you’ll love the 2012 Mazda 5. With enough room for six adults, sliding rear doors that make it easy to get to...
3 Essential Things to Know About Your Car’s Turn Signal
The turn signal on your vehicle is mounted on the front and back of the vehicle, on both the...
The Top 5 Selling Cars in Arkansas in 2012
Arkansas, Arkansas, like many other states, has to deal with a wide range of weather, from the stifling to the icy. This means drivers need vehicles that can handle the heat while also helping them get through slippery conditions. In...