Q: Reprogram

asked by on

How much will it be to reprogram my car

My car has 170000 miles.
My car has an automatic transmission.

It all depends on what needs reprogrammed. Most dealers will have to do most programming procedures and will charge about 1.5 hours and should be expected to cost anywhere in the $175 to $250 range depending on dealer labor rate they charge.

Was this answer helpful?
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: Throttle body issues

Hello, and thank you for writing in. The Ford electronic throttle bodies have a history of failing unfortunately. You may even want to look up warranty and recall information for your vehicle based on your VIN. The new unit that...

Q: What type of ATF for ford fusion se 2009

Hi Sam. For the 2009 Ford Fusion, you'll want to use a Motorcraft Genuine Ford Fluid XT-10-QLVC MERCON-LV Automatic Transmission Fluid. You should purchase a service and repair manual for your Fusion for specific instructions on how to complete this...

Q: Car's electrical completely dies at first crank. Battery is brand new and has been tested at 505 amps.

Hello, thank you for writing in. Electrical issues like this can be tricky. The first thing you should try is starting the vehicle with another battery. Pull a known good battery from another vehicle, and try it in your car...

Related articles

How Long Does a Distributor O Ring Last?
The distributor is part of the ignition system in your vehicle and its purpose is to route high voltage from the ignition coil to the spark plug. The spark plug then...
Rules of the Road For Iowa Drivers
Driving on the roads requires knowledge of the rules, many of which are based on common sense and courtesy. However, even though you know the rules in...
P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...