Q: Rear Driver side axle bearing

asked by on

My husband is a mechanic but can't determine through research if this is a hub assembly or does the whole axle shaft need to come out to replace a wheel bearing on the rear driver side?

My car has 150000 miles.
My car has an automatic transmission.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details
  1. Home
  2. Questions
  3. Rear Driver side axle bearing

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: My manual car starts but will not move on any gears.

What you are describing sounds like potentially a worn out clutch. As you know, the clutch transmits engine power to the gearbox, and allows transmission to be interrupted while a gear is selected to move off from a stationary position,...

Q: What are the most common reasons my car won't start?

Be sure any engine immobilizer system (security system) is not activated, thus preventing the car from starting. "New" batteries are not necessarily fully charged when you buy them over the counter. Consequently, it has to be confirmed that the battery...

Q: Q: Car sputtering.

You need to have the car checked for a fuel leak at the fuel filter and the fuel system. The fuel filter has been known to leak if the filter is not a factory replacement. An aftermarket filter man not...

Related articles

P0052 OBD-II Trouble Code: HO2S Heater Control Circuit High (Bank 2 Sensor 1)
P0052 code definition HO2S Heater Control Circuit High (Bank 2 Sensor 1) What the...
Rules of the Road For Iowa Drivers
Driving on the roads requires knowledge of the rules, many of which are based on common sense and courtesy. However, even though you know the rules in...
P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...