Q: Problem with intake manifold

asked by on February 02, 2016

I got trouble code P0660. Something about the intake manifold tuning control circuit.

Intake Manifold Gaskets Replacement $149.15 - $809.82 Get a Quote

Hi. This trouble code occurs in sync with a ticking noise within the circuit. If the manifold has lose bolts or was not put together correctly after maintenance this can be the result of the code. I would recommend having the vehicle examined by a knowledgable technician, such as one from YourMechanic, and replace your intake manifold if necessary.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

What others are asking

The remote or the inside unlock button will not lock or unlock doors

The door lock actuators that lock and unlock your doors can become weak and won't have quite enough power to fully move the lock mechanism inside your door. This can happen for a couple of reasons. The individual actuator is...

Car makes grinding sound

The alternator is one of the most common problems, as is the idler pulley. These would need to be checked to see if this is the noise. The best way to diagnose the problem is to have a mechanic listen...

The AC/heat blower fan - 1997 Dodge Avenger

Hey there. The most common failure where the fan only blows on high is the blower motor resistor. It is possible the blower motor switch is the culprit, and it can be replaced separate of the control module. Diagnosing...

How do you put a 1996 Dodge Dakota 5.9 360 motor in a 1999 Jeep Grand Cherokee Laredo with a 4.7 in it or a 4.0?

Hi there. You will have to swap the engine and transmission as a unit with the computer and harness to the other vehicle. There will be a need to fabricate engine mounts if the old mounts will not mount up...

Throttle Body, PCV tube, and valve cover seal needs replaced.

Billing question sent to CS for replacement cost of the PCV tube and valve cover seal.

Wheezing when i press he gas more than 30 mph

Hello. The noises you are hearing are impossible to fully diagnose without the vehicle here. Lets begin with talking about that Check Engine Light. The light illuminates when certain codes are sent to the main computer. Not all codes...

Back wheels locked up

Hi there. When back wheels lock up an issue with the brakes arises. This issue is usually your rear brakes not being adjusted correctly. Also, this can be caused by a jammed parking brake. i would suggest having a mechanic,...

water comes into passenger side while car washing

When it comes to water leaks only a hands on test like you did will tell you where the leak is. Why the leak happens is most likely the body was not sealed at the factory good enough and as...

Changed heads and now it won't start. Dodge dealer said no compression

Hi there. For the valve seats to drop out of the cylinder head(s), the engine overheat must of been severe. Assuming you followed proper procedure replacing the cylinder heads. This would lead me to believe it to be the compression...

Related articles

The Best Used Cars to Buy For a Graduation Gift
Your Your little bundle of joy has grown up and on the cusp of entering adulthood. Graduating is a milestone, and you want to reward their hard work and show how proud you are. Buying a used car is a...
The Best Used Cars to Buy for Dog Owners
Dog Dog owners are a special breed of drivers. When they shop for a used car they have a list of requirements that can be quite different from other drivers, which tends to make the process a bit of a...
How Long Does an Intake Manifold Runner Control Last?
Having Having the right air and fuel mixture in a car’s engine is the only way for it to run at peak performance. Older vehicles really had no way to control the flow of air that came into their engine....