Q: on a 2006 ford expedition eddie bauer liftgate window pops open when unlocking and unlocking car with fob key pad

Either side of the rear seat-back can be adjusted by pulling on the levers on either end of the seat. Pull on the lever on the right side of the seat-back to adjust the right side, and pull on the...

You should have the A/C drains checked to see if the drains are blocked causing the water to leak into your 2008 Mercedes Benz R350. Dirt and debris that gets in the A/C evaporator case can clog the A/C drain...

You would need to have the entire crankcase ventilation system checked and serviced first to make sure all the PCV valves are clean and working correctly, or if excessive oil will be consumed and get in the intake. The turbo...

Hello. You did not supply a vehicle model or year so I would have to speculate that you have a bad transmission or axle problem. The grinding noise can be internal gears of the transmission or the axle not engaging...

An overheating engine can be caused by several components. A new thermostat is a great place to start, and knowing that it is not the problem we can focus elsewhere. If the thermostat was suspected, then you may have another...

If your vehicle uses DOT 5 (silicone-based) fluid, the flush interval (https://www.yourmechanic.com/services/brake-system-flush) is much, much longer than 2 years or 32,000 miles. However, if your vehicle uses glycol based fluid, it should be thoroughly removed from the brake system roughly...

Hi Corey: Believe it or not, this issue happens more frequently than you might believe. In most cases, it's caused by the tensioner pulley being slightly misaligned. When you replace the serpentine belt (https://www.yourmechanic.com/article/how-to-replace-a-serpentine-belt-by-mia-bevacqua), it's important to align the pulley...

This may be a sign of low transmission fluid (https://www.yourmechanic.com/services/transmission-fluid-service) or a faulty transmission control solenoid. As you know, automatic transmissions use pressurized hydraulic fluid to change gears. Every time a gear change is required, the car's computer activates a...

When the engine is cold, the engine coolant temperature sensor must be working properly to signal the PCM to enrich the mixture on cold start. If there is a fault with that sensor, you can experience rough idle idle as...