Q: noise from front of the car

A couple of different things could cause the front end to lock up like this, though it is a rare sort of problem to occur: the transfer case circuit has failed driveshaft issue ujoints axles locked-up brakes The vehicle is...

I would talk to the insurance company if you have full coverage with a low deductible so you can get the rim and tire replaced. If you decide to not go with the insurance route then you should at least...

This sounds like you may have internal transmission issues on your 2005 Chevrolet Blazer. It could be caused by low transmission fluid (https://www.yourmechanic.com/services/transmission-fluid-service), a faulty shift valve, or possibly burned clutches. Smell the transmission fluid. If it smells burnt, then...

Hey there, thanks for writing in about your 2010 Lexus HS250h. The anti-lock braking system (ABS) is designed to prevent wheel lockup during emergency braking. The ABS control module monitors the vehicle wheel speed sensors to determine when lockup may...

Hi Jo: Unfortunately, we need more specific information about your vehicle in order to recommend a service or to guess as to what's going on with your vehicle. If the engine is low on oil (https://www.yourmechanic.com/services/oil-level-is-low-inspection) it tends to make...

Hi there, thanks for writing in. Although Lucas makes an exceptional transmission fluid stabilizer, you should try to find out why the transmission is damaged in the first place. If the fluid level was drained to the right level and...

Hello - these are likely unrelated problems - although all frustrating. The engine misfire will require further diagnosis based on ignition codes. There was likely another problem code - perhaps for an ignition coil or misfiring plugs issue (https://www.yourmechanic.com/question/engine-misfiring_2). It...

Hi there: It is very possible that your AC compressor is the source of this type of noise. Much like other accessories driven by the engine’s belts, the AC compressor has several interior components and uses a sealed bearing to...

Hi Cherrill. Thanks for contacting us today. If the water temperature was not consistent, then it's likely that the coolant is not correctly flowing through the system. This could be the thermostat is not opening, allowing coolant to leave the...