Q: Q: Misfire

asked by on

I have a 5 misfire shakes when given gas, has new spark plugs, fuel pump, and engine checked

My car has 255653 miles.
My car has an automatic transmission.

You should have the computer checked to get the misfire codes to what cylinder is misfiring and check for spark from that coil and if you have spark at the coil then have compression on the engine to see if there is a compression problem. If it is okay and even over the engine then you would need to have the fuel injectors checked.

Was this answer helpful?
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: Where is the body control module located on my pickup?

The BCM is under the center console up near the front near dash. One of the seats need to be removed first, then you will need to remove center console. Once the console is removed you can then access the...

Q: Q: Problem with battery.

The corrosion problem is due to the battery acid leaking onto the cables and causing the failures. The alternator may be overcharging the battery or it could be the battery temperature sensor causing the battery to be overcharged. The recommendation...

Q: Dashboard lights out and something draining new battery

Hello there, thank you for asking about your 1957 Chevrolet Bel Air. Checking for parasitic draw on a battery can be done by inserting an ammeter in series with the negative battery cable, then removing the fuses one by one...

Related articles

How Long Does a Distributor O Ring Last?
The distributor is part of the ignition system in your vehicle and its purpose is to route high voltage from the ignition coil to the spark plug. The spark plug then...
What are the Car Pool Rules in Hawaii?
Hawaii is widely regarded as a land of vacation and relaxation, and as such, its scenic roads and routes are far better known than the state’s freeways. But, as with all...
P2103 OBD-II Trouble Code: Throttle Actuator Control Motor Circuit High
P2103 means there is a fault with the throttle actuator control motor circuit, likely due to a defective electrical component or part.