Q: JVC KD-R462 Settings
I cannot seem to find a way in wich the brightness of the button zone will remain at the value that I set it to permanently. The buttons only dim when I fiddle with the controls once more. It's highly annoying at night. I would appreciate any and all advice. Thank you in advance.
Hi there:
Your best bet is to contact JVC directly and ask them to send you an owner or instruction manual for the model of stereo you have.
The statements expressed above are only for informational purposes and should be independently verified. Please see our
terms of service
for more details
Get an instant quote for your car
Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing
What others are asking
Code p-3190/3191
Hello. This can be caused by a number of things. I would start by having the engine battery tested. If it is low or dead then this will occur. If it is fine then there may be another issue with...
Engine cranks but won't start. VTM-4 engine light is on. OBD shows codes P0365, P0340 & P0132
You say you turned off the engine as soon as the vehicle was stopped. Does this mean the engine still runs? The VTM-4 light is for the traction control (https://www.yourmechanic.com/article/how-does-traction-control-work) and you may have a problem with the system, which...
Bluetooth works engine off
Hello. EMI (electromagnetic interference) is electromagnetic energy that is passed through electronic devices. EMI is disruptive and can affect bluetooth devices and/or your GMC Safari's electronic system if not properly shielded. This is not a common problem, but it is...
Can I drive my car even the brake and abs light on or not?
Hi, thanks for writing in. It is not recommended to drive the vehicle until you have the brake system diagnosed to find out the problem. If the ABS has a bad sensor then this disables the ABS system but the...
I need to know the diagnostic procedure for dtc p0717. Want to test wires before taking out transmission
If the sensor only has two wires, it is a reluctant AC sensor. If the sensor has three wires then it is a hall effect DC sensor. A two wire sensor will produce a sine wave signal: '()(-)()(-)(_)' or steady...
My car will not crank and has a yellow exclamation point on the dash.
Hi there. There seems to be a couple of things that are not functioning. First the battery seems to have a low power and possibly a burned cell. Also, the fuel system may have air in it due to running...
How do you figure out which engine mounts actually need replacing?
With all most 200k miles you most likely have all four mounts needing replacement. The first thing to do is to physically look at each one and look for rips or tears in rubber, sagging or oil soaked. Once all...
Car will not start when the engine is hot.
Hi there. If there is fuel and the engine will not start up when it is at operating temperature, then either the crankshaft position sensor is getting hot and not making a connection or the coolant temperature sensor (https://www.yourmechanic.com/services/coolant-temperature-switch-sensor-replacement) is...
Related articles
How Long Does a Hood Lift Support Shock Last?
There There are a number of instances where you will have to get under the hood of your car. Whether it is to do a visual inspection or to find out what is causing issues, being able to lift the...
How to React If Your Battery Light is On
The battery light or charging warning light (https://www.yourmechanic.com/article/the-check-engine-light-demystified), available on the dashboard of your car, indicates malfunctioning or poor charging of the battery....
How to Replace an Anti-Lock Brake Pressure Switch on Most Modern Cars
Anti-lock brake systems (ABS) have a pressure switch that fails if the the light appears on your dashboard or there is wheel locking during braking.
Browse other content
Maintenance
Estimates