Q: I would be drivin then the hand for the temp guague would drop and little then pick back up, it happens every 2 minutes

There are many things that can cause a no start condition. If your timing belt broke, for example the engine on your vehicle is an interference engine, meaning it hits itself internally when the timing belt breaks. This usually bends...

Hello. Dashboard lights blinking (https://www.yourmechanic.com/article/what-does-it-mean-when-the-dashboard-warning-lights-blink) are a common electrical issue with this vehicle. Most of the time, if the battery is fine, it is a connection issue on the negative battery cable ground connections (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-battery-terminal-ends). The connections become corroded or...

This issue is normally caused by low fuel pressure or a faulty injector, but since you have just replaced the fuel pump, this may also be a sign of a failing idle air control (IAC) valve. This is a unit...

Hello, the concern you have I strongly advise not to drive. The issue needs to be addressed, the vehicle will become inoperable. The automatic transmission has 3 systems; electronic, hydraulic, and mechanical. What describe could be an internal mechanical...

Hi there. Believe it or not, many of these codes can be cause by a faulty O2 sensor that has been allowed to continue without repair. The fault sounds like it is definitely a failed O2 sensor, but there could...

Hello, thank you for writing in. The EGR valve (https://www.yourmechanic.com/services/exhaust-gas-recirculation-egr-valve-replacement) (exhaust gas recirculation valve) takes exhaust emissions and recirculates it back into the air intake as to lower toxic emission levels. The EGR valve itself is pressure regulated, and needs...

Hello, thank you for writing in. The first possibility that comes to mind is the air intake sensors. Start by making sure idle air control valve, throttle, and EGR systems are all working well. These types of components can be...

Hi there. The biggest problem with bushing and bearings is that although they progressively wear out, when they fail, it can happen quickly and without notice. I would strongly recommend having a professional mobile mechanic come to your location and...

As long as you have four jack stands to support the vehicle you can remove the rotors and pads from all four wheel positions. If you do not have four jack stands, you can NOT remove the rotors and pads...