Q: i have just installed a led light kit

asked by on

i have just installes a led light kit , do i leave the low beam cover open or just close it as usual when installing normal lights

My car has 123000 miles.
My car has an automatic transmission.

Without knowing which kit was used and how it was installed I will answer this the best I can. With any electrical parts, the most common failures are due to heat and corrosion. Any wiring should be sealed as close to factory as possible to avoid early failures down the line.

Was this answer helpful?
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details
  1. Home
  2. Questions
  3. i have just installed a led light kit

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: Q: The car has no electrical power at all

Hi. I would recommend to have a technician check for any loose power or ground wiring. There also could be some corrosion present that is blocking the electrical current flow. I also recommend that the technician use a test light to...

Q: My 2005 Kia Sorento doesn't have the power to go down the road. It will start and run, but it won't go faster than 35 mph.

Check to see if any vacuum lines were disconnected when your engine was serviced. A vacuum leak can cause the engine to have a loss of power under a load. If all of the vacuum lines are good, then the...

Q: My trunk won't open , I tried the remote and the inside latch, it still won't open

YourMechanic offers a specific service to resolve the issue that you are writing in about. Please see YourMechanic's trunk latch malfunction service page for full details as to the possible causes of the issue that you are having. If you...

Related articles

How to Avoid Back Pain in a Car
If you have back problems, sitting in a car for an extended period of time can be excruciating. Even without back problems, you could experience discomfort and soreness from...
P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...
P2103 OBD-II Trouble Code: Throttle Actuator Control Motor Circuit High
P2103 means there is a fault with the throttle actuator control motor circuit, likely due to a defective electrical component or part.