Q: No spark with new ignition coil

asked by on

We have replaced the igiontion coil and still no spark. We have tested the ignition fuse and it has no power ether. Have no idea where to go from there.

My car has 104000 miles.
My car has an automatic transmission.

You probably have a bad crankshaft sensor. If the computer does not read a signal from the crank sensor when trying to start the car, it does not send power to the fuel pump or ignition coil. A certified technician from YourMechanic can assist in the replacement of this sensor if need by.

Was this answer helpful?
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details
  1. Home
  2. Questions
  3. No spark with new ignition coil

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: Engine turns over but won't start. Could it be a sensor and how do I check?

Hi there. There is a possibility that no power is being supplied from the ignition switch to the power distribution center fuse. The ASD relay fuse may have blown on the ground "control" side of ASD relay. Circuit tests need...

Q: Car has rough idling, occasionally seems it would stall

Hello. Replacing the fuel injectors will not cause this. If it only stalls at idle, I would clean the throttle body first. If it is dirty, then this will occur. If it is fine, then it may be an air...

Q: Tachometer slowly rises while driving (1500 rpm after 5 min, 4000 rpm after 10) regardless of gear

Hi there. Check the VSS (vehicle speed sensor) on the transmission for any loose wires. If the wires are tight, then remove the VSS and clean it off, then put it back in and retest. If the symptoms come back,...

Related articles

P0240 OBD-II Trouble Code: Turbocharger Boost Sensor B Circuit Range/Performance
P0240 code definition Turbocharger Boost Sensor B Circuit Range/Performance What the P0240 code means P0240 is an OBD-II generic code triggered when the Engine Control Module (ECM) detects the intake boost...
Rules of the Road For Iowa Drivers
Driving on the roads requires knowledge of the rules, many of which are based on common sense and courtesy. However, even though you know the rules in...
How to Avoid Back Pain in a Car
If you have back problems, sitting in a car for an extended period of time can be excruciating. Even without back problems, you could experience discomfort and soreness from...