Q: I have a 1993 honda accord ex and I'm trying to put in a new battery but when I attach the negative terminal it sound like I'm sit

asked by on September 28, 2017

I have a 1993 honda accord ex and I'm trying to put in a new battery but when I attach the negative terminal it sound like I'm sitting on the alarm, what can I do for it not to do that?
My car has an automatic transmission.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing


Experienced Mechanic?

Earn up to $70/hr

What others are asking

Whats the cause of a whining tramsmission, blinking overdrive light, hesistant to shift properly?
As a rule, I NEVER change the transmission fluid on a vehicle with that high of a mileage unless it has replaced regularly throughout the life of the vehicle. Replacing fluid that is thick with new fluid can cause issues...
Every three months, catalytic converter and muffler must be replaced
I would start with checking the O2 sensor (https://www.yourmechanic.com/services/oxygen-sensor-replacement). This is what relays exhaust gas changes to the vehicle's computer. When this sensor is not working correctly, incorrect or misdiagnosed air/fuel mixtures are relayed to the vehicle's computer causing incorrect...
Despite repairs, vibrations and droning noise persist - 1997 Ford Aerostar
Hello. With the information I have, it sounds like there could be an issue with the rear differential of your van. A droning noise from the rear could be caused by one of the wheel bearings, or the carrier bearings...
I'm trying to start my car I put the cables to charge once I Take off cables it dies can you tell me wats wrong
Hi there. Diagnosing an electrical issue without inspecting the vehicle is very difficult. However a few things you might want to check on your BMW includes the battery, alternator or other electrical relay's such as the battery cables. The best...
Vibration when accelerating at 55 to 60 mph
Hi there: Sometimes motor mounts or other components that are damaged can mask or hide other issues that cause similar symptoms. Although it's quite possible that the center bearing or transmission yoke could be bent and cause the vibration; those...
Car stalled in stop and go traffic.
Your car may have a dirty or failing idle air control valve. The idle air control valve (https://www.yourmechanic.com/services/idle-control-valve-replacement) reads the air intake as it is mixed with fuel prior to being injected into the engine at low speeds and at...
how long does it take to fix the center bearing driveshaft when in the shop
Hi there. That's very difficult to answer due to the multiple variables involved in removing and replacing hard to access components such as the center driveshaft on a front wheel drive vehicle like your Edge. However, in general, this type...
I've changed valve seals and all gaskets I'm getting gray smoke from tailpipe in 2000 Silverado
Gray smoke suggests burning oil but you can use a scan tool to look at fuel trims and see if perhaps rich operation is contributing to the problem as well. With regard to replacing the seals, if the valve guides...

Related articles

The Best Used Cars to Buy If You're in a Wheelchair
Being Being in a wheelchair means you have a very specific list of demands, and requests for your vehicle. The main focus is of course how you will get in and out of the vehicle. There are some other aspects...
The Top 5 Selling Cars in Arizona in 2012
Depending Depending on where you live in Arizona, the weather is either arid or there may be periods of heavy snow – such as in the mountain areas. The vehicles that have been popular in previous years for the area,...
How to Modify the Alpine Navigation in an Acura or Honda
Modifying Modifying the original equipment manufacturer (OEM) navigation system of your Acura or Honda vehicle with aftermarket software is an easy way to add additional customization features to the already-installed system. Using a simple third-party computer program and a DVD-ROM...