Q: I figured out the problem, now I need a solution

asked by on

The iac valve is good when I turn on the key the valve clicks and doesn’t move, but if I unplug the negative wire and turn car on and touch the negative to the battery it s working perfect. So would this be a fuse or what with my ignition.

Hi Danny. Without completing an actual inspection, it’s impossible to tell you for certain.

Was this answer helpful?
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details
  1. Home
  2. Questions
  3. I figured out the problem, now I need a solution

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: My truck runs for about 20 minutes and then dies. After few minutes starts back up. Changed fuel pump and few other things

Try cleaning the mass air flow sensor as these sometimes get dirty which can cause it to not run well or at all in some cases. Without additional detail as to what else has been changed, it is tough to...

Q: Instrument cluster shuts down

Hi. A check of the wiring going from the instrument cluster to the BCM is needed. A lot times there is a broken wire, shorted circuit, short to ground, or a corroded wiring or connector. These are all usually the...

Q: When I come to a stop my truck will lunge forward and sound like it revs up a little

This may be a sign of a faulty MAP sensor as the vehicle responds adversely to a load put on the motor (i.e. putting it in gear, making turns (which makes use of the power steering pressure switch) turning on...

Related articles

How Long Does a Distributor O Ring Last?
The distributor is part of the ignition system in your vehicle and its purpose is to route high voltage from the ignition coil to the spark plug. The spark plug then...
Rules of the Road For Iowa Drivers
Driving on the roads requires knowledge of the rules, many of which are based on common sense and courtesy. However, even though you know the rules in...
P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...