Q: How do I use the console box in a 2012 Toyota Camry?

The parking brake release Warning Light is located on the instrument panel. This light illuminates when the car is traveling more than 4 MPH and the parking brake is engaged. When you see this light, either stop the car or...

The problem is most likely the motor for the power antenna. Motors wear out over time (28 years) and will eventually stop working. I would first check the fuse to see if it is blown, if so the antenna motor...

The code P0014 is for the cam sensor but since you already replaced it, then you will have to have the camshaft end play checked per a technical service bulletin (TSB) to see if it is in excess of specifications....

You could have several things contributing to the hard start (https://www.yourmechanic.com/services/car-is-hard-to-start-inspection). Dirty or faulty throttle valve, idle air control valve, bad temperature sensor, and more. I suggest having a certified technician, like one from YourMechanic, perform a few tests to...

In this case you should have an experienced technician look at the vehicle. Limp mode is usually a term used for a vehicle with an automatic transmission which stays in second gear when certain faults arises. A certified technician, like...

Hey there. The three different Check Engine codes (https://www.yourmechanic.com/services/check-engine-light-is-on-inspection) you mentioned (P0420 (https://www.yourmechanic.com/article/p0420-obd-ii-trouble-code-catalyst-system-efficiency-below-threshold-bank-1-by-jamahl-walker), P0133 (https://www.yourmechanic.com/article/p0133-obd-ii-trouble-code-o2-sensor-circuit-slow-response-bank-1-sensor-1-by-blake-griffin), and P0171 (https://www.yourmechanic.com/article/p0171-obd-ii-trouble-code-system-too-lean-bank-1-by-andrew-quinn)) would need to be diagnosed first to see why they are stored in computer memory. You will need the mechanic clear the...

Thanks for your question. If it's a wheel bearing, the noise generally doesn't go away with speed although it might appear that way because the noise gets masked by other noises such as road noise, wind and exhaust. It is...

As with most modern cars, things are more complicated than they seem. The BMW uses a lamp control module to power up the lights. It's not a simple switch-load connection anymore. Among other functions, the lamp control module senses malfunctions...

Hi there. A situation like you've described could be caused by a sensor that has become loose or the electrical harness connected to it has fallen off. It's also common for an ignition coil pack to become loose when the...