Q: How do I set the seat belts in automatic locking mode?

asked by on

How do I set the seat belts in automatic locking mode?

Automatic locking mode is a feature that keeps the seat belts from having any slack. This feature should always be used when attaching a child restraint system. To set the system, follow these steps: 1. Buckle the seat belt. 2. Pull the shoulder strap downward until the entire belt is extracted from the retractor. If the belt is an inflatable belt, then instead of this step, pull the lap belt upward until the entire belt is extracted. 3. Release the belt and allow it to retract. 4. Try and move the belt to make sure that it is locked.

Was this answer helpful?

Need advice from certified mechanic? Get help now!

Over 1,000 mechanics are ready to answer your question.
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Ask a Mechanic
(100% Free)

Have a car question? Get free advice from our top-rated mechanics.

Ask A Mechanic
Over 10,000 questions answered!
  1. Home
  2. Questions
  3. How do I set the seat belts in automatic locking mode?

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: How do I switch between the rearview mirror day and night setting?

The rearview mirror has two settings: day, and night. The night setting is designed to reduce glare from bright headlights, and should always be used at night. It also provides less clarity, so it should never be used during the...

Q: Third row seat not going down in 2007 Mercury Mountaineer

Hi. There are two 30 amp fuses that control the rear seats. Fuse 5 controls the left and fuse 12 controls the right rear folding seat. These fuses will need to be checked along with the relays that control each...

Q: I have an 97 Ford Explorer and recently fix my water pump, radiator upper and lower hoses but my coolant reservoir tank is empty

Check the coolant levels when cold and fill to the cold line on reservoir and then start and warm engine to see if the coolant is full to the warm level. You may have just not filled the coolant all...

Related articles

How Long Does a Distributor O Ring Last?
The distributor is part of the ignition system in your vehicle and its purpose is to route high voltage from the ignition coil to the spark plug. The spark plug then...
P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...
P2103 OBD-II Trouble Code: Throttle Actuator Control Motor Circuit High
P2103 means there is a fault with the throttle actuator control motor circuit, likely due to a defective electrical component or part.