Q: How do I replace the washer fluid?

asked by on

How do I replace the washer fluid?

Occasionally you will need to replace your washer fluid. To check the status of your washer fluid, raise the hood, and locate the washer fluid reservoir. Look at the reservoir to see how full it is. If it is nearly empty, lift off the reservoir cover, and add more washer fluid. Replace the cover when you are done.

Was this answer helpful?
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details
  1. Home
  2. Questions
  3. How do I replace the washer fluid?

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: How do I start the car if the immobilizer system is active?

The immobilizer system is responsible for keeping the car from turning on with an unregistered key. If the system is not allowing you to turn on the vehicle with a registered key, it is likely because of the presence of...

Q: Vehicle rumbles when driving also a very loud noise when driving over lane strips.

Hello, thank you for writing in. There are several issues that may cause these types of symptoms. The most common are improperly inflated or unbalanced tires. If you lost a weight off of the tires while driving, this would cause...

Q: Rust on the hood and doors

Your hood condition is no coincidence, there is a well documented reason why the corrosion/bubbling is more concentrated to your hood. Ford knew about this happening back in 2000 when they started using Aluminum hoods to lower vehicle weight. When...

Related articles

P0240 OBD-II Trouble Code: Turbocharger Boost Sensor B Circuit Range/Performance
P0240 code definition Turbocharger Boost Sensor B Circuit Range/Performance What the P0240 code means P0240 is an OBD-II generic code triggered when the Engine Control Module (ECM) detects the intake boost...
Rules of the Road For Iowa Drivers
Driving on the roads requires knowledge of the rules, many of which are based on common sense and courtesy. However, even though you know the rules in...
P2103 OBD-II Trouble Code: Throttle Actuator Control Motor Circuit High
P2103 means there is a fault with the throttle actuator control motor circuit, likely due to a defective electrical component or part.