Exception in rendering!

Message: window is not defined

ReferenceError: window is not defined
    at new c (/tmp/execjs20161208-83728-dayanqjs:136:3912)
    at m.mountComponent (/tmp/execjs20161208-83728-dayanqjs:47:15602)
    at /tmp/execjs20161208-83728-dayanqjs:49:31860
    at a.r.perform (/tmp/execjs20161208-83728-dayanqjs:47:12503)
    at Object.a [as renderToString] (/tmp/execjs20161208-83728-dayanqjs:49:31821)
    at r (/tmp/execjs20161208-83728-dayanqjs:50:21164)
    at Object.S.ReactOnRails.serverRenderReactComponent (/tmp/execjs20161208-83728-dayanqjs:32:6073)
    at eval (eval at <anonymous> (/tmp/execjs20161208-83728-dayanqjs:173:8), <anonymous>:10:23)
    at eval (eval at <anonymous> (/tmp/execjs20161208-83728-dayanqjs:173:8), <anonymous>:17:3)
    at /tmp/execjs20161208-83728-dayanqjs:173:8

Q: How do I change the Language?

asked by on

How do I change the Language?

A: The Base Message Center is a helpful tool w...

The Base Message Center is a helpful tool when looking at how your vehicle is performing. For your convenience, you can change the Language of the Base Message Center to meet your needs. To change the language of the message center.

  1. Press the Setup button until the Language option appears.

  2. Press the Reset button to start scrolling through the Language options.

  3. Press the Reset button again when you see the Language you wish to set the message center to.

Was this answer helpful?

Need advice from certified mechanic? Get help now!

Over 1000 mechanics are ready to answer your question.
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Save up to 30%

Get a quote

What others are asking

Q: Is it normal to have 1/8 turn backlash on front drive shaft?

The driveshaft will have some slack when you turn it back and forth when the 4x4 is not engaged and the front hubs have not locked in. The 1/8 turn may be normal. If you have engagement problems for the...

Q: Replacing button lights dashboard

Hello. The bulbs cannot usually be replaced individually. In order to fix this problem, the entire control unit will have to be replaced. This does require that the dashboard be removed in order to replace the climate control. A certified...

Q: Rubbing noise when turning sharply to right and straight

Hi there: If you're getting a grinding or rubbing noise as the vehicle is turning and also going straight, it's most likely caused by wheel bearings that are faulty or wearing out. However, it could be other front end suspension...

Related articles

How Do Power Car Windows Increase Passenger Safety?
Power windows are responsible for approximately 2,000 emergency room visits every year. When a power window closes, it exerts enough force to bruise or break bones, crush fingers, or restrict an airway. Though...
P0052 OBD-II Trouble Code: HO2S Heater Control Circuit High (Bank 2 Sensor 1)
P0052 code definition HO2S Heater Control Circuit High (Bank 2 Sensor 1) What the P0052 code means This code is seen when the Engine Control Module (ECM) tries to control the...
P2103 OBD-II Trouble Code: Throttle Actuator Control Motor Circuit High
P2103 means there is a fault with the throttle actuator control motor circuit, likely due to a defective electrical component or part.