Where does a egr hook on the exaust on ford escape 2004 3...

Where does a egr hook on the exaust on ford escape 2004 3.0 ...

Where does a egr hook on the exaust on ford escape 2004 3.0

Automotive Expert
Hi! Welcome to JustAnswer. Thank you for contacting us for assistance with your vehicle. I'm Ron. I will be happy to assist you with your question. May I ask to whom I have the pleasure of speaking with today?

Automotive Expert
Hi Troy. Nice to see you today! I'm sorry to hear you are having this problem. I know this can be frustrating. Please give me one moment to type out some information for you. Sit tight one minute... I'll be right back! Thanks for holding, Troy. On this vehicle the EGR Tube connects the EGR Valve to the rear [exhaust](/topics-exhaust-ford/) manifold. For an image location view, click here: <u><strong><a href="https://bit.ly/3iVWzbS" target="_blank" rel="nofollow">https://bit.ly/3iVWzbS</a></strong></u>. Disconnect the EGR tube nut at the manifold connector. Carefully remove the differential pressure feedback EGR sensor from the EGR tube. Disconnect the EGR tube fitting and remove the EGR tube.

you are full of it if you think I will pay $26-.. for a call,I was sure it was some kind of sham.
Automotive Expert
My apologies for the phone call offer. This is sent by the website... Not Me! I have no control over it! No need to take the phone call. I can help you right here in Q&A! Please scroll up or refresh your browser. I posted my reply above.

sorry thanks for the digram,
Automotive Expert
You're welcome, Troy! Glad I could be of some help today! I hope everything works out well for you! Have a great day! Thank you for choosing Just Answer for your questions!

What others are asking

What does the Autolamp function do?
Your car is equipped with an auto-off feature that turns the headlights off after a specific period of time. This is an important safety system that helps prevent the chance of leaving your headlights on and thereby draining your battery...
Need to replace O2 sensor
When a Check Engine Light is illuminated it can be scanned by a tool. The code that gets read by the computer signifies what needs to be changed/replaced. An O2 sensor code quite possibly may be the case, but a...
I have a 2010 saturn outlook XE AWD, I have noticed that my temperature gauge goes from 210 to 235 while I drive over 70 mph
You may have a problem with the radiator not flowing through all the channels and this will cause the engine to run hotter at higher speeds. You may also want to check the radiator cap (https://www.yourmechanic.com/services/pressure-test-radiator-cap) to see if it...
Can shaft position sensor all of the outcomes of the problem
Possibilities: 1 - Simply replacing the camshaft sensor (https://www.yourmechanic.com/services/camshaft-position-sensor-replacement) will solve your problem. 2 - If it does not, with the age of the vehicle, there can be a break in the wiring harness to the cam sensor. 3 -...
Engine won't crank with a new battery, new starter and new positive battery connection.
Hi there. It is very possible that you have an ignition system component failure that is causing your car not to crank over and start. It could be the ignition relay, starter relay or a faulty ground wire. Before you...
Volvo s40key was stuck won't crank clicking from fuse box
It may be that you have low system voltage. That might be because of a dead battery, or it might be because of an interruption in the power distribution. But since everything is computer controlled these days, if the system...
inner tie rod torque spec on a 2006 nissan maxima ?
The inner tie rod nut should be torqued to 90 to 100 foot pounds and secured with lock.
My car has no oil, the only oil I have available at the moment is 5w-30 but my car requires 5w-20 is it ok if I put it in? Will it
5W-30 is perfectly OK to use on this vehicle on a temporary basis. The only detriment, and it will be hard to detect without complex measuring equipment, is the higher viscosity 5W-30 technically creates "pumping losses" in the engine which...