Q: Clutch went out

I would say the most common problem if you reversed the leads would be a blown fuse. If it's not that then you may have melted a wire or even fried the ECM. I would suggest getting a technician such...

Hi there. A humming noise usually indicates a worn pinion bearing or an incorrect backlash setting on the rear differential between the ring and pinion gear. Sometimes, if the pinion bearing develops play due to wear, the pinion gear will...

Hi. The chirping sound you are experiencing on your 2010 Nissan Cube sounds like it could be from noisy strut springs (https://www.yourmechanic.com/services/suspension-springs-replacement) or a worn drive belt (https://www.yourmechanic.com/services/serpentine-drive-belt-replacement). Check the condition of the strut springs and drive belt to try...

Hi there. Usually when the motor becomes flooded or has a hard time maintaining a solid idle, it's caused by either a vacuum leak or a malfunctioning idle control valve (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-idle-control-valve). However, this issue may also be caused by bad...

There several potential causes for this. First, there could be a vacuum leak somewhere. In addition, a relearn procedure must be performed after replace the ETC actuator. It's possible that the dealer missed this step. Finally, there could be a...

Hello, thank you for writing in. The timing belt is responsible for keeping the camshaft and the crankshaft in sync so the valves will open and close accordingly. With that said, the vehicle is likely not going to run at...

If your clutch is slipping (https://www.yourmechanic.com/article/how-can-i-tell-if-my-clutch-is-slipping) you will be able to hear the engine rev, and the tachometer rise without any apparent acceleration of the car. It tends to happen in the higher gears because that is when the load...

The theft system is active and may have an issue with the key or the system. You will need to try your second key to see if light goes out? If it still stays lit then you will need to...

Hi Juan. The ETC light is an indication of a fault with the Electronic Throttle Control. This system is responsible for relaying your physical input when applying pressure to the throttle pedal and sending this data to the throttle body....