Took instrument cluster off unplugged key cylinder plugge...


Took instrument cluster off unplugged key cylinder plugged back in 2007 chevy malibu. Now car won't start check [engine](/topics-engine-chevy/) and car lock light stay on when key is in on postion Mechanic's Assistant: Doe...

Took instrument cluster off unplugged key cylinder plugged back in 2007 chevy malibu. Now car won't start check [engine](/topics-engine-chevy/) and car lock light stay on when key is in on postion Mechanic's Assistant: Does the light stay on, or does it blink? Stay on Mechanic's Assistant: Are you fixing your Malibu yourself? What have you tried so far? Turn key to on three 10 minute cycles disconnected battery. Manually lock doors open drivers side door after locking and unlocking practically everything on YouTube key fob is not working


Mechanic2007 chevy malibu car won't start car lock on steady lightTried almost all youtube fixes none work
Automotive Expert
Hello and thank you for using JustAnswer. My name is \*\*\*\*\* \*\*\*\*\* I will do my best to assist you. During this conversation you will be given an automated offer for a phone call. You may accept or decline that offer. They are sent thru by Justanswer and not me. So Please IGNORE them unless your PREFER a PHONE CHAT! I’m sorry that you’re having trouble with your vehicle. I will do my best to help you resolve them. Please understand that I do not know your knowledge or capabilities so I may need to ask questions to find out basic information to help solve your specific problem. My aim is to give you the best service possible and to help you. If you have any questions or concerns, please don’t hesitate to let me know. Sometimes it may take a moment for me to respond because I may have to look up information about your concern. I appreciate your patience and will provide responses as soon as possible
Automotive Expert
Have you tried the 30 minute relearn a few times sometime it take 3 or 4 cycles to reset

I did
Automotive Expert
Have you scanned the bcm and the security module for fault codes?

I have a scanner but not a great one tried to scan it no codes popped up
Automotive Expert
it needs to be more of a prograde tool a generic engine only tool will never do it usually its a failed key cylinder/ passlock sensor

Saw about a transmitter toogle switch can't locate in 2007 chevy Malibu. Supposed to turn it off and on while key is in on position. Any idea where that is locatedCould probably borrow one. Is the key cylinder passlock sensor by the ignition I'm guessingDo I get a whole different key cylinder or is that not the same part
Automotive Expert
there is no toggle switch

It did start and run once since it was back together. Speedometer cluster was not working radio was off and car lock. Stayed on solidWhen I got home tried to disconnect battery since then it wouldn't start againThe battery is reconnected now of courseThought tomorrow would continue to do ten minutes on then off and cycle that three or four more times unless you have a better idea
Automotive Expert
a good scan tool or attempt the relearn

Ok will try that thanks
Automotive Expert
You're welcome

What others are asking

Ticking noise in my engine.
A ticking noise sounds like a bad valve lash adjuster and is a common problem with these cars. I would have a technician inspect the noise from your engine (https://www.yourmechanic.com/services/noise-from-engine-or-exhaust-inspection).
Doors do not lock/unlock with keyfob buttons
I would recommend going to your local auto parts store to test your vehicle's key fob. Most auto parts stores have a key fob tester sitting on their counter in which you can point your key fob at this sensor...
My 08 scion xb vibrates at 55 mph
You did not specify the transmission you have but the problem sounds like an issue with the constant velocity inner joint. When these joints start to have problems with vibration they are known to exhibit problems under a load and...
Rear rotors on a sienna 2013 too thin
Any time a brake rotor is resurfaced to get rid of surface grooves or warpage the cutting off of a layer of the metal is removed until a flat smooth surface is achieved. After the surface is resurfaced the rotor...
Loss of power esp on hills
This may be a sign of a clogged catalytic converter. As you may already know, the catalytic converter converts toxic exhaust gases into less harmful pollutants that are suitable to be expelled into the atmosphere. When this is clogged, this...
Can i remove oil pan from 05 CTS 2.8 without pulling motor ?
Hello, thank you for writing in. The engine will need to at least be partially removed from the vehicle in order to remove the pan. You have to compensate for the oil pick up tube at the bottom of the...
what is an good oil change interval to stick with this car
Toyota recommends changing the engine oil and filter on the 1999 4 cylinder Camry every 12,000 kilometers. Changing the oil, and performing other maintenance, using a mobile service such as YourMechanic (https://www.yourmechanic.com), can save you a lot of money. If...
My car keeps dying after a jump
The problem sounds like the alternator stopped charging. The battery being dead may have overloaded the alternator since they are designed to maintain the battery and run the accessories, not recharge a battery and run all the accessories. I would...
2007 Infiniti fx35 cranking but not starting. Do you know what the problem might be?
Hi there. The fuel pump is not energizing and causing the engine to not start. Check the fuel pump relay and listen for it to click. Also listen for the fuel pump to hum when the key is turned on....