Q: Check engine light
My check engine light is on. I went to my local advanced auto parts to see what codes the machine brings up. The only message that came up was P0442 - evaporative emission system leak detected (small leak).
I was advised to check my gas cap and make sure it is tightened. I have checked and it is secure to me. What else should I be checking or look into replacing in order for the check engine light to go off?
My car has 164500 miles.
My car has a manual transmission.
The statements expressed above are only for informational purposes and should be independently verified. Please see our
terms of service
for more details
Get an instant quote for your car
Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing
What others are asking
Heater only working part of the time.
We need to determine if your blower is blowing air or if the air coming out is not hot. If you feel heat coming through any of your vents, even a tiny trickle of heat, then your heater core is...
Are all the motor mounts the same on the sides and in the front?
No, they aren't. Typically there are four main mounts that support the motor and the transmission. Depending on the parts source you buy from, it is important to be specific about the position of the mount. Mounts may or may...
My cooling fans are not working, what should I check?
Usually if the power supplied to the fan is good (meaning the relay and the fuses), that indicates that the fan motor is broken or you have a ground issue. The best way to know for certain is to check...
When heat is on temperature gauge goes towards cold. When heat is off it goes back to being in the middle. 2001 Buick Regal
Hi there - the temperature gauge behavior you describe would indicate that you need a new thermostat (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-thermostat). The thermostat should keep engine temperature within a close range - close to the center of the gauge from a visual point...
Replaced wiper motor wipers still dont work. Checked fuse. Seems no electrial current
Hi there. Was supply voltage checked at the wiper motor, fuse, wiper switch? If there is no supply voltage at the fuse, then the problem could be in the fuse block or wiring harness. The fuse could have a crack...
I have a 3.6L leo commodore. I'm getting an error code of p0040. I need to swap the sensors plugs. Is it easy to find the connections?
Hi there. The code p0040 (https://www.yourmechanic.com/article/p0040-obd-ii-trouble-code-oxygen-sensor-1-bank-1-by-spencer-clayton) is for an O2 sensor connectors are being swapped. Make sure the O2 sensor connectors aren’t swapped. This can happen when work has been previously performed. Also, check for unplugged or damaged connectors, as...
Mitsubishi Eclipse automatic to manual conversion
There will be more than a few changes to the vehicle you will need to do to facilitate this swap. The wire harness, computer, engine and trans mounts, computer, clutch pedal assembly and other items that may not be mentioned....
I have a 2007 Infiniti G35 sedan, when pressing the pedal softly I get a slight delay in acceleration, and sometimes a small jerk
Hi there. Typically when an engine "bogs down", it is caused by a fuel or air restriction issue. Common components that can cause this are mass air flow sensors, MAP sensor, EGR valve, fuel injectors being dirty or clogged or...
My car is bucking at low speeds and while in drive at stop signs and red lights no codes it's an '06 expedition.
It sounds like you may have a crankshaft position sensor that may be on the verge of failing. A crankshaft position sensor (https://www.yourmechanic.com/services/crankshaft-position-sensor-replacement) is an electronic device used to monitor the position or rotational speed of the crankshaft. This information...
Related articles
Is it Safe to Drive With a Fuel Leak?
A fuel leak is when gasoline leaks from the gas tank of the vehicle. Underneath the car will be a spot of fuel on...
Symptoms of a Bad or Failing Fuel Gauge Sender
If your fuel gauge behaves erratically or is stuck on full or empty, you may need to replace the fuel gauge sender.
How to Replace a Fuel Pump Relay
The fuel pump has a relay that fails when there is no audible humming sound as the ignition is turned and when the car cranks after longer than usual.
Browse other content
Estimates
Services