Q: Car spotters when I engaged to drive and had a whisal sound

asked by on September 26, 2017

When the car is in park,it sounds normal when i put it in drive it putter and shaking

There is likely a problem in the fuel, ignition, or air induction systems. When you put the car in drive, you are "loading" the engine and obviously due to some fault the engine lacks sufficient power at that point to continue to run smoothly. The cause could be as simple as faulty spark plugs, plugged injectors, a faulty mass air flow sensor, EGR system and quite a few other "systems". You could have a vacuum leak. Check for diagnostic troubles codes stored in the engine computer and look, too, at secondary firing patterns at idle to see if those traces (oscilloscope) hold any clues. If you want these steps performed by a certified Mechanic, dispatched by YourMechanic right to your location, please request a sputtering diagnostic and the responding certified mechanic will get this taken care of for you and get your car running smoothly again. If you have further questions or concerns, do not hesitate to re-contact YourMechanic as we are always here to help you.

Was this answer helpful?
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Replaced front calipers and pads, rotor on right front, but passenger side rotor is still burning and smoking?

You will need to check the caliper slides are not binding and are lubed properly. If okay then with wheel off see if rotor is binding and then open the bleeder on the caliper to see if it releases the...

Bad fuel pump? 2004 BMW X3

Hi - short answer is "No: a fuel pump problem will not cause a camshaft position sensor problem". But, we all know Murphy's 2nd or 3rd law says that 2 things can fail close enough together to make us believe...

overheated and I cut it off started after cooling and died after a few min.

Your car doesn't have a timing belt, so it's not likely that it has "Jumped time." But if the car was low on coolant and overheating, it doesn't take much driving to do some engine damage. So it could be...

Related articles

3 Essential Things to Know About Your Car’s Gas Tank
The The gas tank of the vehicle holds the fuel, which makes the car run. The fuel is propelled by the fuel pump. The gas tank can be made out of plastic high-density polyethylene, which can be made into complex...
P0568 OBD-II Trouble Code: Cruise Control Set Signal Malfunction
P0568 P0568 code definition Cruise Control Set Signal Malfunction What the P0568 code means P0568 is an OBD-II generic code that the engine control module (ECM) or body control module (BCM) identified a voltage signal for more than 90 seconds...
A Buyer's Guide to the 2012 BMW X3
If If you like high-end SUVs, the 2012 BMW X3 is definitely worth taking a look at. It’s a great mixture of luxury, utility and convenience. Key Features The Servotronic power steering on this SUV is excellent for giving you...