Q: ABS light and traction control come on while driving, go away after restart.

asked by on December 29, 2015

ABS light and traction control comes on, and then goes off when you turn car off and restart the vehicle.

ABS Light is on Inspection $79.99 - $99.99 Get a Quote

I would have the car scanned with an ABS scan tool to have the problem diagnosed.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

What others are asking

Intermittent chirping when driving with AC on

Hi. When the AC compressor is on, it puts a significant load on the belt, tensioner, pulleys and engine. The extra load on these parts could be the cause, or the internals of the compressor could be the source of...

Vibration when applying brakes and when steering.

This may be a sign of warped brake rotors and/or potentially failing wheel bearings. When your brake rotors get hot due to the heat caused by friction, they can develop hot spots in them which causes an uneven surface area....

Ac not blowing out of vents turns on but doesn't come out

Hi! It is sounding like you may have a bad blower motor control module. It is located under the dash next to the blower motor. A technician can test it with a volt meter to verify its proper operation. I'd...

My check engine light turned on and it also notified me that the traction control turned off

I do not recommend driving the vehicle until the car is diagnosed as to why the lights came on. The issue may constitute your vehicle to be unsafe to drive and should only be driven only to get to a...

The following dashboard lights came up at the same time (ABS, TSC OFF, TSC/DSC).

Hello. If all of those warning lights have suddenly come on then there is likely some sort of issue with the vehicle's ABS and stability control systems. Common causes for these lights are issues with the vehicle's wheel speed sensors...

what is the firing order

The firing order for your 2005 Chevrolet Aveo is 1-3-4-2.

My car only accelerates directly after I start it. After a short period, it stops responding to the gas pedal being pressed.

You will need to have the computer scanned and the fuel pressure tested to see if the pressure is low. Since there is a problem then the system tests will identify the cause of the loss of power. You either...

Car won't start. Could a sensor be at fault?

With the limited information available, I can only assume that no testing has been done at this point in time. You will want to start by running a scan for codes. This will tell you of any electrical issues the...

My 2005 chevy malibu eeduced engine power light is on after i pushed in some fuses

If the reduced power started immediately (first key start) after you worked around the fuses, there is probably an electrical cause. If there was any delay at all though, that raises the possibility of mere coincidence, in other words the...

Related articles

How to Replace an Anti-Lock Brake Pressure Switch on Most Modern Cars
Anti-lock brake systems (ABS) have a pressure switch that fails if the the light appears on your dashboard or there is wheel locking during braking.
I Hit the Brakes Very Hard. Did I Create a Flat Spot on My Tires?
Almost Almost everyone, at some point in his or her driving experience, will slam on the brakes. Slamming on the brakes is generally more than just an emotional response to a situation. When you're avoiding an accident or reacting to...
How Disc Brakes Work
Car disc brake systems are made up of the rotor, brake pads, pistons, and caliper. The pistons push the pads into the rotor to slow or stop your car.