Q: A/C not working n my 2008 Honda Accord.

A faulty ignition switch is the most common cause of the problem you are having, but it is not necessarily always the cause; for instance, you could have an issue with your ignition lock cylinder, or linkage. I recommend that...

Hello. A P0135 code indicates that there is a malfunction of the oxygen sensor/heat circuit. This problem could cause the car to burn more gas and over time, cause damage to the catalytic converter. When the oxygen sensor is replaced...

Hello. It sounds like you have a steering lock or ignition switch problem. Most of the time the switch fails which will turn the ignition off and lock the steering. I typically take the steering column apart to inspect the...

P0442 (https://www.yourmechanic.com/article/p0442-obd-ii-trouble-code-evaporative-emission-control-system-leak-detected-small-leak-by-spencer-clayton) indicates that you have a small leak in the evaporative emission system. Many times this is caused by a loose or faulty fuel cap (https://www.yourmechanic.com/services/gas-cap-replacement). Make sure that the cap is tight and in good condition, so that...

The antenna wire should not be connected to anything that would cause the car to not start, especially if it is getting power to crank. I would suggest checking to see if the spark plugs are getting fuel to them....

This may be related to a faulty transmission control solenoid (https://www.yourmechanic.com/services/downshift-solenoid-replacement) or low transmission fluid. As you may know, automatic transmissions use pressurized hydraulic fluid to change gears. When a gear change is required, the car's computer activates a transmission...

Typically a clicking sound is caused by metal-to-metal contact, caused either by a lack of lubrication or metal fatigue; which may have been caused by overheating. If the sound is coming from the engine, and increases as the engine revs...

Hello. There are a couple of things to check here. When the antifreeze was added, was the cooling system thoroughly bled (with the heater turned to "Max" heat and fan? There could be air bubbles in the engine or heater...

The loss of power and the brake issue have separate causes. Vibration on braking is usually due to defects in the brake rotors, particularly warping and thickness variation in the rotor. Improperly mounted rotors can also cause vibration. To resolve...