Q: Q: Shifting problem

asked by on

2007 Saturn Ion automatic with 69,000 miles started erratic shifting and shifting up at wrong speeds and feels like it's slipping and has no power when accelerating after driving a few hours in the Arizona heat . Car from California only been in az. For 2weeks

My car has 69000 miles.
My car has an automatic transmission.

What you are describing may be a result of a faulty speed sensor, potentially low transmission fluid or a even a faulty transmission control solenoid. As your vehicle travels down the road, the computer analyzes data being sent by vehicle speed sensors and engine speed sensors. Based on this information, the Engine Control Unit (ECU), or the Transmission Control Unit (TCM), executes the appropriate upshifts and downshifts by sending a signal to one of several shift solenoids. These transmission solenoids have spring-loaded plungers inside them, which are wrapped with wire. When this coil of wire receives an electrical charge from the TCM / ECU, it causes these plungers to open, allowing transmission fluid to flow into the valve body and pressurize the desired clutches and bands. When this happens, the transmission changes gears and you continue down the road. The computer controls the transmission solenoid in several ways. If the vehicle is equipped with a dedicated Transmission Control Unit, it can open or close the hydraulic circuit using a direct 12v signal. In some cases, the Engine Control Unit (ECU) can control the solenoid’s plunger by turning the ground circuit on and off. When this is not working properly, this can cause a jerking reaction, a delay in shifting or in some cases may cause the transmission to hesitate in shifting gears. I would recommend having a professional from YourMechanic come to your location to diagnose and inspect your transmission.

Was this answer helpful?
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details
  1. Home
  2. Questions
  3. Q: Shifting problem

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: Where is the camshaft position sensor located on a 2005 Saturn ion 2.2l?

Hi there, thanks for writing in. This engine does not have a camshaft sensor, but uses the ignition module to detect when cylinder number 1 and 3 are at top dead center using the coils internal circuits. You may need...

Q: Hearing brake noise

First the noise needs to be tracked down to the specific components or system affected. Noises can come from worn components along the suspension system. Wheel bearings or drive belt pulleys are common failure items. Brake pads will definitely cause...

Q: Rattling noise from front driver tire after wheel bearing replacement

Hi there. On a front wheel drive vehicle, the only two items that could possible cause this, besides a wheel bearing that was not properly lubricated and installed during the replacement, would be a brake caliper that is dragging on...

Related articles

P0052 OBD-II Trouble Code: HO2S Heater Control Circuit High (Bank 2 Sensor 1)
P0052 code definition HO2S Heater Control Circuit High (Bank 2 Sensor 1) What the...
P0240 OBD-II Trouble Code: Turbocharger Boost Sensor B Circuit Range/Performance
P0240 code definition Turbocharger Boost Sensor B Circuit Range/Performance What the P0240 code means P0240 is an OBD-II generic code triggered when the Engine Control Module (ECM) detects the intake boost...
P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...