Q: 1996 Ford F-150 pick up truck isn't shifting into reverse

This issue may be related to a malfunctioning crankshaft or camshaft position sensor. These sensors monitor the position of both shafts and send feedback to the PCM (engine computer) which then sends signals to multiple other things such as fuel...

Hello there. There are a few potential causes for why the car would have charging faults even after the alternator is replaced (https://www.yourmechanic.com/services/alternator-replacement). The most common would be the battery cable (https://www.yourmechanic.com/services/battery-cable-replacement), shorted harness, battery (https://www.yourmechanic.com/services/battery-replacement), or a failed alternator...

Hello. The power steering pump (https://www.yourmechanic.com/services/power-steering-pump-replacement), power steering lines, and/or steering gear could be faulty or have a leak. The problem you are having with your accelerator pedal being hard to press could be due to a throttle cable that...

Hello...to service spark plugs on your vehicle, you must disconnect the negative battery cable. Inasmuch as the vehicle's Idle Air Volume Learning, Steering Angle Sensor Neutral Position, Sunroof Memory Reset/Initialization, Automatic Drive Positioner System, Audio presets and Navigation settings will...

It is possible the catalytic converter got hot enough to fail on the last trip you took before this started. No pressure from the exhaust is a good sign that the car can't breath. This may be because it cannot...

Hi There, This is definitely a timing issue and most likely related to a camshaft position sensor failing and potentially bad spark plugs and/or wires. The camshaft position sensor is a magnetic sensor that monitors camshaft speed to regulate ignition...

I'm going to assume you have the CFT30 continuously variable transmission (CVT). There are two filters on this transmission: a traditional internal filter and an external 'High Pressure' filter. To remove the internal filter, first remove the transmission pan. Then,...

You will need to go to a dealer and present your car and proof of ownership is the only possible way to get the information you need. This is if the ignition was never changed before.

Magnasteer was not an option on the 2011 Impala so what you are looking at is an irrelevant catalog entry (an error in the parts catalog). However, several different rack and pinion units were installed on the 2011 Impala and...