Although you added fluid, did you check to see that the level was in the appropriate mark for what the temperature the engine is (cold/hot)? If so, its likely that the pump bearing has failed and which means the unit...
Hello. I would need to know the exact codes to be able to give good information about this. If you have a reoccurring misfire code, then a compression test needs to be done to see if there is an internal...
Hi, have you taken the car to get the computer scanned? Typically when the ABS light is on the Check Engine Light should also be on, this lets you know that the computer has detected a fault in the ABS...
Dependin where the exhaust leak is can cause the O2 sensors to not get correct amount of gases in the exhaust and cause the rich running condition. I would suggest having the computer codes pinpoint tests be done to see...
This may be a sign of a faulty MAP sensor as the vehicle responds adversely to a load put on the motor (i.e. putting it in gear, making turns (which makes use of the power steering pressure switch) turning on...
Check the brake fluid in the master cylinder reservoir and see if its low. If the fluid is low then top it off with Dot 3 brake fluid and see if the light goes out. If the brake fluid is...
The level of refrigerant in the air conditioning system would not affect the noise level of the blower motor. If you replaced the motor with an aftermarket (non OEM) motor that could create an issue in terms of the quality...
Hi there. The vehicle sitting only week, should not have caused a grinding noise from the right front wheel upon brake apply. I would assume, the right front brake pads are touching metal to metal (https://www.yourmechanic.com/services/brake-pads-replacement). Continued driving will cause...
The computer will run self tests as the vehicle is turned on, and while the vehicle is driving. There are certain circumstances for each test that must be met for the computer to turn off the check engine light. The...
Hi there, thanks for writing in. The traction control module (https://www.yourmechanic.com/article/how-long-does-a-traction-control-module-last) is a part of the ECM, but usually is a separate component from the main control module. The best way to solve the issue is to have a professional...
You should have the complete fuel system to include the vapor system checked for any leaks. You may have a leaking seal on top of the fuel tank that is leaking vapor that is getting into the passenger compartment.
This vehicle has a starter relay that is mounted in the main fuse box inside the car. This is most likely the cause of the no crank condition you are having. I recommend you have the relay inspected (https://www.yourmechanic.com/services/car-is-not-starting-inspection) by...
Hi Adrian. Thanks for contacting us today. If you've just replaced the battery and it still will not crank over, then it's likely that a different electrical issue exists. If you can turn the key and the lights and other...
Hi Tyler. If the transmission fluid was a dirty brown when it was replaced, it's possible that you've got an inner seal that is faulty - or the transmission fluid filter is corroded, creating a blockage inside hydraulic lines. I...
The differential inside the transmission may be worn or have an issue with the bearings that is causing the clicking noise when loaded on the opposing side to the load applied when driving. Try to see if the noise occurs...
Be sure the battery is fully charged. "New" batteries are not necessarily fully charged at time of sale. Of course, confirm that the engine immobilizer system (security system) is not activated. With the key held in the "start" position, you...
The oil that the manufacturer recommends is 5w30 and it is the only oil that you should use. If you try to use a thicker 10w30 or 10w40 then you may be not lubricating the engine good enough. The thicker...
Your car was built right on the cusp of the period when Honda products were transitioning to distributor-less ignition. If it is a model that had a distributor, then that is the first place I would look for trouble. The...
Hello there, a few common faults will cause your 2003 Acura CL to overheat and have the check engine light illuminated. Without knowing what codes your vehicle is displaying I can only offer general advice. The thermostat and gasket are...
This sounds like potentially a catalytic converter issue in addition to broken exhaust mounts. The smell of fuel along with the overheating suggests that the catalytic converter may be clogged. As you may know the catalytic converter converts toxic exhaust...
