Hello - there will be 2 tasks here. The first is to match the door lock(s) with the ignition switch key tumbler if you wish for one key to do everything as a new car would. This can be done...
Hi, most vehicles now a days have an electronic lock that releases when you step on the brake pedal. The lock is a safety feature that keeps the transmission from being put into gear accidentally. If the lock gets stuck...
In order for you to make this decision you need to compare the value of the car before and after the replacement of the transmission. If the cost to replace the transmission exceeds the value of the car then it...
If you had your brakes removed and hub will not turn freely then it is the bearing in the hub. I would recommend replacing both front hub bearings since they both have equal amount of wear and the other side...
If this "just started", it may be that there was trapped air in the system, since you did the water pump replacement, and so all you are doing is providing make up coolant at the moment. But, if the coolant...
I don't have the wiring diagram for this vehicle handy, but one thing to check is the brake light switch. Hyundai actually issues a recall on these switches. I suggest you call the dealer with the VIN of your vehicle...
The pinion engages with a ring gear and the other end of the pinion is supported on a tapered roller bearing. If there is any radial play in the pinion itself, there is a problem with the bearing and/or the...
After any sort of impact with the suspension you can have a series of parts that need to be replaced. When a mechanic comes across a situation like this the first thing that would be done is a visual inspection....
The water pump may be the cause, but it may also be the tensioner and pulley. The belt would need to be removed, and water pump pulley, as well as all other pulleys, checked for binding or problems. I recommend...
There could be an issue with the transmission torque converter or the clutches forward and reverse are coming on at the same time inside the transmission causing the engine to stall out when shifting into gear. I recommend seeking out...
It is very possible that the transmission may require a full rebuild or a replacement in order for it to perform properly. Although you are able to shift into other gears, if certain gears are not working correctly, transmission damage...
I am not sure who would have told you to clean or unclog the converter out with lacquer thinner, but that is not a very good idea, and you shouldn't do it. The thinner may damage the converter internal material,...
If you are referring to the engine coolant temperature gauge on the instrument panel, unless the gauge is misreporting the temperature, a likely cause of too low of an engine temperature is a cooling system thermostat that is stuck in...
If your driver side window is not going up, it is possible that the regulator or motor has failed. Sometimes they come together as one unit, sometimes the motor is replaceable by itself. I would recommend having the vehicle looked...
You might want to remove both PTOs first. They may be seized or have bad bearings. You may also have burned out the input bearings. The transmission will need to be removed and torn down to see what the damage...
Hello. There are a few reasons why this is happening. The tachometer on the instrument cluster may be bad, and the instrument cluster may need to be replaced. There also could be a problem with the speedometer shaft and its...
It definitely sounds like you are experiencing a charging issue. The alternator is the component responsible for charging the battery in a vehicle. System voltage needs to be a minimum of 12 volts. Anything less than this could potentially create...
If the engine cranks fine as soon as you connect jumper cables then you most likely have corrosion on the inside of the battery clamps where they touch the battery post. You should disconnect each battery clamp and clean them....
It is possible that maybe the connections on the battery terminal ends are not tight enough or secured properly. I would recommend getting a wrench or socket to try and tighten up the battery terminal ends to ensure a good...
The check engine light code may shine a little light on the concern. It almost sounds like you may have an issue with air metering or fuel delivery. A cold/malfunctioning idle air control valve can put air flow. A leaking...
The remote keyless entry system is not only a great convenience, but it increases vehicle security by being able to lock or unlock the doors from a distance. If the range of the remote decreases, there are a few points...
