To play a CD, you will first need to insert the CD. Insert the CD by slowly sticking it into the CD slot, face up. Do not force the CD in; it will feed itself in. When you insert a...
Ticking is usually valve train related. Your engine has hydraulic lifters, they are self adjusting. One thing that can go wrong is the rocker stud can pull out of the head. They are pressed in originally. Check the nuts have...
Typically if the unit is functioning and the wiring harness is solid, the sound should come from the speakers without any customization or reloading any software. If you didn't replace the original wiring harness, this is likely the source of...
You will need to set the crankshaft to No. 1 top dead center or TDC. There should be marks on the crank pulley that indicates where this is. If you have already done this, you may be 180 degrees out....
The most common issue that occurs after a timing belt snaps is that your engine won't start. Another common issue, depending on whether you have a freewheeling engine design or non-freewheeling engine design, is a piston making contact with a...
Hello, thank you for writing in. Turbocharged versions of your vehicle want an oil change every 3,000 miles due to increased engine use. A non-turbocharged version of your vehicle wants an oil change every 5,000 miles. The driving habits of...
First check to see if any OBD-II codes have set. A real time scanner can be used to check the operation of the throttle position sensor - TPS. TPS faults are a common cause of the symptoms you are describing....
Hello, thank you for writing in. If it is an aftermarket blower motor, as opposed to an OEM original dealer part, that might account for the noise. That would be my first suspicion, especially if you are sure you have...
When this occurs, there are a few usual culprits. The most common include: the key fob failing, the car's security system is malfunctioning, or the door lock actuators have failed. The other door lock actuators failing is the most unlikely...
Check for proper oil level to be sure the engine has adequate lubrication. There is a recall for a fuel supply system problem (clogged fuel system vent) that MAY be an issue here (Recall 14V464000). Check with your Suzuki dealer...
There are a few common problems with your vehicle. The first is a problem with the EGR system. There is a pipe that cracks at a flex joint and causes a small exhaust leak, but that is normally heard all...
Hey there. This is likely a short in the power window switch or potentially faulty or pinched wires. I would suggest removing the door panel to trace the wires to the power switch to make sure they are all connected...
This could be a serious issue and needs to be looked at immediately. It is possible a fuel leak has developed in the fuel supply or return line. This leaking fuel could be ignited and fire could result. The entire...
The Check Engine Light is likely still on due to the oxygen sensor faults. The unfortunate thing is that engine computers sometimes cannot detect another problem if they are dealing with one already. That may be why it didn't have...
When a car overheats when it is sitting still or moving slowly, this is because the cooling fans are not turning on. If the car is fine while moving, the thermostat is fine, although, anytime a motor overheats, it can...
Hey there, thanks for writing in about your 1998 Chevrolet Blazer. It sounds like you may have a problem with the fuel pump. Sometimes when they wear out, they develop a dead spot. By hitting the tank, it jolts the...
Try and see if the throttle sticks when the engine is not running. If the throttle does not stick, check the throttle plates for carbon buildup. This can cause the plates to stick when it is running. Cleaning off the...
Greetings. It is somewhat expected for seals to stop preventing leaks after a few years of usage. If it is the front seal as you believe it to be, the transmission will have to be dropped to replace it. There...
I checked multiple aftermarket catalogs, the Dodge OEM catalog and even E-Bay for possible gray market junk but I can find no listings for separate upper ball joints to install in the upper control arm for your vehicle. For some...
Hello, There are many reasons that may cause a vehicle not to start, however a malfunctioning neutral safety switch can certainly be one of the causes for this. The neutral safety switch will prevent the vehicle from starting when it...
Hello. If the fuel injector system leaked fuel into the engine it may have caused a fuel vapor lock of the engine. A mechanic could get the engine to turn again by removing spark plugs and checking the oil to...
Hi, thanks for writing in. When a hub seal is installed, the lip on the hub seal will want to be on the top when you are pressing it in. There is always one side that is slightly wider than...
