Popular questions

Question
Car overheating and shutting off
Hi. An engine that is not able to keep itself cool is at serious risk of significant damage. There is a good chance that the head gasket has been damaged as a result of overheating and should be replaced along...
Question
Clunking car when I go over bumps
Basically, any bolted on or "jointed" moving part or bushing could account for noise in the front end. Not included in your list are rack and pinion mounts/bushings, strut bearings, tie rod ends, even brake parts (caliper torque plate), loose...
Question
Maintenance other
When routine service or maintenance is due the ECU activates this warning light to let you know. However, in most cases, the light needs to be cleared after the service manually. If you look in your owner manual, you should...
Question
My car is making a clicking noise when I turn. 2002 GMC Envoy
Hello. If the vehicle is four wheel drive then it very well can be an axle that is failing. If the vehicle is two wheel drive then it does not have axles in the front. If that is the case...
Question
Hello, I have a 2005 mustang and was driving and the steering wheel and brakes all of a sudden locked up then the car died. It rol
The engine stalling would need to have the computer scanned to see if there is stored codes to indicate a problem? The leaking brakes should be repaired by whoever did the brakes and may be unsafe to drive and should...
Question
Car goes into limp mode when the check engine light and VSA light comes on
The lights that you have on and the vehicle going into fail safe mode is an indication you have a major system failure that will require computer to be tested for codes first. There are many possible codes it can...
Question
Car stalled in stop and go traffic.
Your car may have a dirty or failing idle air control valve. The idle air control valve reads the air intake as it is mixed with fuel prior to being injected into the engine at low speeds and at idle....
Question
Clunking when shifting - 2001 Jeep Cherokee
The "clunk" indicates there is a loose coupling somewhere is the driveline. As you diagnosed, u-joints and the differential are the most likely fault points, but this could also be harsh engagement of the transmission due to worn clutches, clutch...
Question
Why does my thermostat not read anything on dash board 1994 Dodge Ram
Hello. If the gauge does not move at all even when the vehicle is turned off and on then the gauge is bad. If the gauge cycles but then does not move when the vehicle is turned off and on...
Question
My truck runs for about 20 minutes and then dies. After few minutes starts back up. Changed fuel pump and few other things
Try cleaning the mass air flow sensor as these sometimes get dirty which can cause it to not run well or at all in some cases. Without additional detail as to what else has been changed, it is tough to...
Question
Overheating issue with my 1994 Honda Accord
Stop leak products will plug up cooling passageways, particularly in the radiator, and consequently OEM manufacturers such as Honda discourage use of these products. In any vehicle, if there is a "leak", of anything (oil, refrigerant, coolant, etc.) the leak...
Question
What is draining my car battery?
Hello There, It sounds like you may have some potentially faulty wiring that may be causing a draw on your battery when sitting for long periods of time or potentially a faulty voltage regulator that is not properly regulating the...
Question
Wheels are not riding smooth
In the process of refinishing the wheels, the personnel at the dealer should have rebalanced the wheel and tire assembly as well. You may want to return to the facility to have the balance of the wheels checked or take...
Question
Car maintainence
Hi, thanks for writing in. You will need to have a mechanic scan the computer to see what codes are stored and pressure test the oil pressure to see if it is a sensor or internal engine problem. The tire...
Question
Thumping and shaking noises - 2013 Jaguar XK
If you are feeling this "shaking" through the steering wheel as well as "seat of the pants", it is likely your tires. While siting overnight, especially in cold weather, they develop a short-term "flat spot" where the tire rests on...
Question
My dealer told me that I should replace the oil pump along with the timing belt
Hi There, There are a number of differences between the oil pump and the water pump, however the main difference is that the water pump pumps the coolant through the motor and is driven by the timing belt and the...
Question
My mom has a 2006 Chrysler PT Cruiser. It started but when put into reverse or forward it dies. What is going on?
You should check the transmission to see if fluid is low first since the problem is in the transmission. If fluid is full then you will need to have the transmission checked for stuck overdrive solenoid or leaking internally on...
Question
What does the service engine soon Warning Light mean?
The service engine soon Warning Light is located on the instrument panel. This light illuminates solidly when the on-board diagnostics system (OBD-II) has noticed a malfunction. If the light is blinking, then the OBD-II has detected that the engine is...
Question
Transmission
Hello there, The Chevy Aveo most certainly does come with a 4 speed automatic transmission. The 5th gear you may be feeling is the overdrive function of the 4th gear. 18 mpg seems quite low for this size of vehicle...
Question
No start until the gearshift is moved around in park - 1992 Toyota Cressida
If the shifter has to moved around in order to get the engine to start, then this indicates either a faulty or misadjusted gear selection switch on the transmission. In order to prevent the vehicle from starting up in drive,...
Question
Window broken
Hi there. If the window has suddenly stopped working, then the most common reason is because the window motor failed. I would typically remove the door panel and check for power at the window motor when operating the switch. If...
Question
After hitting a median, my slip indicator light came on. I had the struts replaced today but the light stays on. Any suggestions?
If you hit something and bent a strut, it is very possible that your wheel speed sensor wiring was stretched. If the wheel speed sensor wiring was stretched or damaged in any other way, It could be the cause of...
Question
High idle after replacing fuel pump tps and air idle control valve
The first thing to do is to verify there are no vacuum leaks in the engine and verify the installation of the parts. Once this is done then disconnect the battery and then let sit for two minutes and reconnect...
Question
Car will start and run smoothly but will die when you try to accelerate.
Hi there. There may be a misfire on a cylinder that is causing the engine to hesitate on acceleration. Check all of the spark plugs and wires and see if they have burn marks. If there is burn marks on...