Popular questions

Both codes refer to the oxygen sensor that is to the rear of the catalytic converter. With regard to Code P0037, if the rear oxygen sensor is brand new, you should check the heater circuit ground (the oxygen sensor has...

The car is not safe to drive with the fluid leaking. It is most likely the transmission line leaking and driving it will damage the transmission. Have the vehicle towed to body shop.

Hello. The emergency release can be achieved from the transmission itself. This problem typically occurs when there is a failure in the shifter assembly or it can be a computer problem. I have ran across a few of these that...

Hello there. Is your Jeep four-wheel-drive? A clicking or popping noise can come from a CV joint with a torn grease boot. The boot develops a tear or leak and the grease will leak over time until the joint is...

There are two possibilities. This could be caused by internal wear in the transmission. Fluid level and condition should be checked. If the fluid level is low or smells burnt it may be an indication of an overhaul needing to...

Hi there. Check the fuel injectors one at a time by disconnecting the harness and see if the engine stumbles or not. If the engine stumbles when the injector is turned off, then the injector was working. If the engine...

Hi there. Unfortunately, the P0430 OBD-II trouble code is not something that would cause excessive coolant usage. The P0430 code is set when the ECU detects below threshold performance from the catalytic converter. The ECU monitors the catalytic converter closely...

You can choose whether your vehicle’s clock has a 12-hour format, or a 24-hour format. To do so, open the infotainment center and press the Config button, then select Time Settings. Highlight the button that says 12/24 Hour Format, then...

Hi there - engine tapping noises under load are usually connecting rod bearing problems, although it is possible that it's just a weak valve lifter. Hard to say without hearing it. If you have a sound byte to pass to...

The VANOS unit or solenoid can cause a rattling sound from the engine. The VANOS is a camshaft timing system which runs off of engine oil pressure. If the oil is the wrong viscosity or the system has a buildup...

Your vehicle uses an electric transfer case motor to switch from 2WD to 4WD, and that motor or the associated wiring may be failing and switching itself over bumps. I would begin by checking the wiring and connectors to the...

To have a technician verify the condition you could leave your car overnight with the dealer or contact YourMechanic and schedule an early appointment so either technician would be there to start the vehicle first thing in the morning. ...

It may be hard to figure out why the engine failed without knowing if the oil leaked out or was not filled up. I have seen situations where after performing an oil change the oil leaked out from an oil...

Hello. Thanks for writing in. Just like your door, there is a switch that is controlled by the manual opening and closing of the trunk. When the trunk is opened, the switch closed the connection which allows voltage to run...

This to me sounds like either an issue with the fuel or ignition system. If the battery was replaced and jumping doesn't help the battery is good. The spark plugs being replaced makes the ignition system is less likely than...

Hi there. Unfortunately, if these concerns weren't there before the repair then they are most likely the result of the repair. Although her intentions were well, there are many mechanics such as this that have similar results. Replacing the steering...

There are a number of things that can cause your ignition to lock up. I am assuming you are speaking of the ignition lock cylinder which is what the key inserts into. The easy one is to turn the wheel...

E-15 is shorthand for gasoline blended with 15% Ethanol which is a fairly corrosive material which can cause damage to rubber parts and other critical parts over time. Ethanol also attracts and bonds with water from the air, and that...

Creaking on turning the front wheels can be due to sticking or failed strut mount bearings and/or faults in the tie rods (inner or outer) or even ball joints. It is also possible that the outer CV joints are worm...

If you are referring to insufficient air flow, the duct network, blower doors and controls and the blower motor should be checked out. On the other hand, if airflow is good (strong) but the temperature of the emitted air is...

You'll need to check the coolant level before driving further. I would also have the mechanic check for a blown head gasket (which would cause the uneven running), and to make sure nothing under the vehicle is dragging. It is...

Engine knock by definition means the combustion taking place is mistimed or improperly detonated. More technically it means the explosion(s) has taken place partially or completely outside of the "envelope" (or area in the cylinder that is designed to push...

The code P0138 is on for two possible different situations. Either the oxygen sensor has shorted out on the exhaust system or the wiring from the battery to the sensor has a short or break in it. Check the oxygen...

Under normal operating conditions, the EPS light comes on when the ignition switch is turn on, then goes off when the engine is started. If the EPS light remains on when the engine is running, there is a problem with...

Hi there. You might want to watch this video on removing the spark plugs on a Dodge V-6 3.6 liter engine. Although this car is different, your Journey has the same exact engine configuration. The random misfire of 1, 2,...