Popular questions

Volvo Contronic service diagnostic tools are required to access that code and perform the required diagnostics. As you may know, YourMechanic certified mechanics primarily repair passenger vehicles and trucks, including commercial trucks and diesels, and thus the diagnostic equipment is...

Hi There, This can happen for a number of reasons and should have triggered a check engine light. Some of the things that may be causing this could be a failing catalytic converter, a faulty oxygen sensor or potentially a...

The most likely cause of these symptoms of this are a failing turbo, large vacuum leak, or a damaged intake. This level of symptom damage to the engine can result from continued driving. If the turbo has failed, it can...

Hi there. Unfortunately, we are unable to attach images or files to this Q & A section, so we're not able to assist you in this manner. I would suggest searching online for a wiring schematic for your 73 Ford...

Hello there, many common faults will cause your 2010 Volvo XC70 to have issues starting. You have done great in replacing the battery already as this is the cause in many cases. Other potential causes are the starter, fuel pump,...

I'm cheap. I buy them, but I buy them used and I don't pay much and I drive them for 10, 20 or 30 years. But, that's just me. The problem with leasing a car is this: if you lease...

Hi there - the rattling noise you describe is likely a heat shield on the exhaust system, or some other bracket attached to the engine/transmission. Engine vibration, however minimal, can cause loose metal to make an awful racket. Since getting...

Hi. The Ford security system has multiple modules that all need to have the same key code saved in order to start the engine. If the unit was flashed at the factory without being inside the car, there is a...

You should not have many problems finding replacement parts for this car. It will depend on the parts needed and supply and demand as with any car part. If you are more specific on the part you are looking for...

When trying to diagnose any brake problems, a thorough brake inspection, along with a diagnostic road test, is needed. A misdiagnosis can lead to a possible brake failure. You could be having issues with brake pads, rotors, or other problems...

Hello - your symptoms suggest someone may have "worked on" this without your awareness of what might have been done. Hate that! You will likely have to get out a voltmeter and start following the electrical path to the plugs....

There is a possibility that when you try to close your moon roof, it will close and then re-open slightly. If this happens, stop your vehicle, and perform the relearning process for the moon roof. Press and hold the CLOSE...

It sounds like you are on the right track. The most common cause would be an issue with the locking assembly but if the car is equipped with a switch to open the trunk that could also be an issue....

A ticking sound coming from the motor can sometimes be normal, but in this case there are a few possibilities. The oil level should be checked by a qualified technician to ensure the motor has enough oil for proper lubrication....

With the age of the vehicle, a worn / failed pinion seal is the most likely cause. Inspect the pumpkin and cover for any damage. If it is apparent that the pinion seal is leaking, make sure the pinion bearing...

Advancetrac is just your traction control system and is not necessarily a safety issue. This is an optional feature for driving a car. Although many vehicles come with this feature standard it is not necessary for normal driving. If you...

It sounds like you may have a leak in the EVAP system causing the car to stall. Your car has a small purge valve with a purge solenoid in the Evaporative Emissions system that controls the venting of fumes from...

Hi there - no, your Honda rims (OEM at least) will not fit on your Toyota Corolla. Even though the bolt pattern is the same, the center bore on your Toyota rims is 54.1mm, but your Honda center bore is...

A lot of times new brake pads will be the type that are metallic and will have small fine metal particles built into the pads that will make noise when first apply brakes in the morning and most times is...

Hi Edwardo. Thanks for contacting us tonight. The P-0300 OBD-II trouble code indicates that there is a misfire in random or multiple cylinders. This could be caused by misfiring fuel injectors, faulty spark plugs, coil packs, or other ignition system...

When you get the transmission fail safe warning, it means the transmission controller has detected a fault in the transmission or in the various sensors that it reads. The controller can adapt to a certain amount of wear and tear...

The EPS light is for a problem in the electronic power steering system and you may also get the check engine light coming on. This is an indication of a problem with power steering and will need to have computer...

Hello. Most of the time when you get squeaks when hitting bumps it is due to worn out suspension bushings or an issue with the struts. I usually get the vehicle in the air and fully inspect the bushings and...

Hello, thank you for writing in. The first assumption we make when the vehicle does not move while in gear, is that the transmission fluid is low. Start by checking the level and the condition of the fluid. If it...

This may be related to a faulty starter solenoid. The starter solenoid is located on the starter and has internal electrical contacts that transmit electricity to the starter. When this fails, it may cause a clicking sound and will not...