Skip the auto shop - Our mechanics make house calls

Q: What do I do if the moon roof won’t close properly?

asked by on

What do I do if the moon roof won’t close properly?

A: There is a possibility that when you try to...

There is a possibility that when you try to close your moon roof, it will close and then re-open slightly. If this happens, stop your vehicle, and perform the relearning process for the moon roof. Press and hold the CLOSE button on the moon roof control panel, in front of the moon roof. While you hold the button, the moon roof will close, reopen, stay open for roughly 10 seconds, close again, tilt open, and close a third time. After this final close, you can release the button.

Was this answer helpful?

Need advice from certified mechanic? Get help now!

Over 1000 mechanics are ready to answer your question.
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Ask a Mechanic
(100% Free)

Have a car question? Get free advice from our top-rated mechanics.

Ask A Mechanic
Over 10,000 questions answered!

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: How do I release a locked steering wheel?

When the steering wheel is locked, you cannot turn it fully, and you cannot turn on your car. To unlock the wheel, simply turn it back and forth while pressing the Engine Start Stop switch, until the steering wheel unlocks...

Q: How do I turn on the audio's repeat mode in a 2012 Honda CR-V?

When in repeat mode, the audio system will repeat the track that you are currently listening to. Turning on repeat mode only takes a few seconds: 1. Press the Setup button. 2. Rotate the selector knob to Rpt One Trk...

Q: I have to change my second gear oil pressure switch I ordered apart it asked upper or lower what does that mean also what tools

There is only one second gear oil pressure switch. It does happen to be the top sensor. You may only need a Phillips screwdriver, pliers, and a small crescent or 18mm wrench to remove and replace the sensor. Make sure...

Related articles

P0052 OBD-II Trouble Code: HO2S Heater Control Circuit High (Bank 2 Sensor 1)
P0052 code definition HO2S Heater Control Circuit High (Bank 2 Sensor 1) What the P0052 code means This code is seen when the Engine Control Module (ECM) tries to control the...
What are the Car Pool Rules in Hawaii?
Hawaii is widely regarded as a land of vacation and relaxation, and as such, its scenic roads and routes are far better known than the state’s freeways. But, as with all...
P2103 OBD-II Trouble Code: Throttle Actuator Control Motor Circuit High
P2103 means there is a fault with the throttle actuator control motor circuit, likely due to a defective electrical component or part.