Popular questions

Question
Car dies, check engine light with codes P0341 and P0346 (camshaft position sensor). Will not start until vehicle cools down.
Hi there. The codes p0341 and p0346 are both related to the camshaft position sensor and are showing that the sensor has lost communication to the computer. Click here for a diagnostic report and diagram about the camshaft position sensor...
Question
08 Dodge ram 1500 , shifter will move thru all gears but will only engage reverse and park??
Check to make sure the shift cable end at transmission is okay and not worn out causing it not to get into gear. If it is okay then the transmission is damaged internally and will need to be computer tested...
Question
Brake sensor is to sensitive causing brakes to flicker while driving. 2005 Mercury Montego
Hi there - your brake light switch needs a minor adjustment. It is adjusted too "tight" or close to the brake pedal lever, or possibly has failed. Adjusting/replacing it will eliminate this flickering problem. I recommend a brake light isn't...
Question
How long does it take to replace the control arm assembly in a Mercedes-Benz S 500?
Hi there. The time for removing and replacing a control arm on a 2000 Mercedes-Benz S500 ranges between 4 to 6 hours depending on the persons experience and if the parts come off easy or not. If you need further...
Question
Stalls and stutters only in the morning when I start it
As a general rule, car engines do not like cold weather and do not do operate as well in cold weather. When you start your car in the morning and turn the key to on, the coolant temperature sensor immediately...
Question
The check engine, Trac off and Vsc light came on my car. The code that came up is P0446 (Evap System Vent Control Fault).
Hi there. That light is not going away until the fault has been properly diagnosed. The code may or may not be the same. The code that is stored is a guide for a qualified technician to use. It does...
Question
Car is grinding after driving a distance but nothing wrong with brakes ?
Hi there. It sounds like it could either axle or wheel bearing related. Low lubricant in either of these can create what your experiencing once heated up during use. A visual inspection of the axle boots may help in identifying...
Question
Change battery message on dashboard
Since your vehicle is a 2011, I highly doubt your battery is still under warranty. Batteries are relatively inexpensive and are cheap insurance. I suggest you have your battery replaced. A professional, such as one from YourMechanic, can do this...
Question
My car keeps cutting off when I put it in reverse and sometimes when it idles.
Hi There, Based upon what you are describing and how the car responds to load, it sounds like you may have a faulty MAP sensor. The Manifold Absolute Pressure (MAP) sensor senses engine load and generates a signal that is...
Question
Why would i keep getting p0013 and p0023 codes when the truck isn't equipped with exhaust cams, it's not a 4 cam engine
Hello - this engine, although single overhead camshaft, does use variable cam timing, actuated by "cam torque", rather than engine oil pressure, to adjust exhaust valve timing (relative to the intake valves). This engine was introduced to Ford trucks in...
Question
Escalade suddenly stop moving like it's in neutral.
Hello. Most of the time this occurs when the fuel pump fails. The lack of fuel pressure will cause the engine to lose all power which will feel like a transmission issue. This will then cause the engine too cut...
Question
Can a running AC harm the car while parked
No, not as long as your cooling fans are working. Cars are made to run all day long with the AC on. If they have the cooling fan working, sucking air over the radiator into the AC condenser. It can...
Question
Can the power steering return hose problems cause the Check Engine Light to come on?
Hello there, you have several different issues going on with your 2004 Toyota Corolla. Without knowing what the Check Engine Light is, I cannot determine if it has anything to do with the engine shaking or not. The power steering...
Question
Mitsubishi Eclipse automatic to manual conversion
There will be more than a few changes to the vehicle you will need to do to facilitate this swap. The wire harness, computer, engine and trans mounts, computer, clutch pedal assembly and other items that may not be mentioned....
Question
What engines will fit into my 94 s10 blazer its a 4 door 2wd
If your VIN has a "W" or "Z" in it the 4.3L engine used in model year 1993 and 1994 will fit and function properly with your existing engine controls. You have to match the VIN to the engine, though,...
Question
KOEO test code 332
Hello there, A few different things can cause insufficient EGR flow. The most likely are: a stuck closed EGR valve a failed EGR valve solenoid faulty oxygen sensor low fuel pressure exhaust leak These can also...
Question
2007 Mercedes-Benz S550 stalls and then turns itself off
If you start the 2007 Mercedes-Benz S550 using the keyless go system and the vehicle is acting erratic, then it may be due to this module being erratic from the battery voltage dropping below a certain level and causing it...
Question
Code for pressure solenoid D
The P2716 code is produced when the ECM has detected that the throttle body actuator motor has failed to read the correct position at which the butterfly valve within the throttle body should be in order to produce a smooth...
Question
Acceleration problems in 2004 Toyota Solara
Your particular vehicle has an electronic throttle body that drives by wire, rather than a mechanical cable. The electronic throttle body relies on signals from the accelerator pedal to know how much to open or close the throttle plate. A...
Question
Clutch not working after replacing slave cylinder and master cylinder
Hello. We will be happy to help you with your vehicle. It sounds like you have a problem with your throw out bearing. You would likely need to drop the transmission once again and check that the installation of the...
Question
How do I access the glove box?
The glove box is located in front of the front passenger seat, and offers a storage space for important items. It is a great place to store your vehicle information, such as your registration and insurance. To open the glove...
Question
My window on my passenger side won't roll down and the lock button doesn't lock the doors.
Hello, thank you for writing in. Your issue is most likely a switch. The window motor would not effect the door lock functions. The only true way to know is to test the power available to the switch and see...
Question
I was driving in the rain and when i went through a dip full of watter, water splashed into my car n got my feet all wet... the wa
Vehicles are far from waterproof in all circumstances. When the vehicle is designed the structure is engineered to keep rain out and most water sprayed from the wheel well areas but if you enter standing water of significant depth, some...
Question
My 2012 Kia Forte has been having trouble with acceleration for the last couple of days. When pressing the peddle the car will sud
Hi Miguel. Thanks for contacting us today. It is possible - however unlikely, that while replacing the brake switch, an error code may have been triggered in the ECU, causing the acceleration problem you are experiencing. What is more likely...