Popular questions

I would suggest check to be sure the Mass Airflow (MAF) sensor is working properly. The symptoms you are describing are very common when this fails. As you may know, this regulates the flow of air into the engine allowing...

Hi there: It's very possible that reduced pressure from a cylinder is an indication of a blown head gasket. In most cases, this problem is caused by damaged piston rings or a hole in the piston, but a blown head...

Hello. The key issue is probably due to a worn ignition cylinder. Replacing the cylinder should do the trick. These vehicles are also known for having the key completely stuck in the ignition due to a failure in the shift...

Hi there. The remote will need to be repaired or replaced and then the new remote would need to be programmed to match the computer system in your vehicle. Then your vehicle will start up properly. If you need further...

Hi Dee. Thanks for contacting us tonight. You might want to watch this video, to learn how to replace the center brake light.

A number of things can effect a vehicle's ability to start in cold weather. The battery can have enough power to to turn on lights and other accessories, but not have enough power to crank the engine. The engine needs...

If the clutch is slipping, then a new clutch will most likely need to be installed. The flywheel will need to be inspected and possibly machined, if there are gouges or hotspots. You may want to enlist the help of...

Hi there. Most of the time this is caused by a bad fuel pressure regulator. Typically, an old fuel pressure regulator will be blown out from the new fuel pump due to the higher pressure. This is going to be...

Hello - "the assembly needs to be changed" seems a bit extreme for a fluid leak. I recommend an oil leak inspection performed by a mobile, professional mechanic, such as one from YourMechanic, who will come to your location, diagnose...

Hi there. In most cases, when you attempt to jump start the vehicle and it doesn't work, it's due to a damaged starter relay, the starter motor or the ignition relay itself. Before you complete any repairs however, it's a...

Billing question sent to CS for replacement cost of the PCV tube and valve cover seal.

Hi there. It sounds like there could be a belt, pulley, or accessory problem. One of these items could be causing your steering concern and the smoke. Are there any visible leaks from the power steering pump? Any leaks from...

This is due to a possible blown head gasket near the number 6 cylinder on the engine. You have aluminum heads and may have a crack in the head. I would recommend having the system checked by a certified technician...

Hi, thanks for writing in. I'd be happy to help you. Code P2104 relates the throttle position control actuator, and code P2126 relates to the throttle position sensor. When either of these components is not working properly, this can cause...

Vibration that is in the floor area and/or the accelerator pedal, but not felt through the steering wheel, could be due to a rear axle (tire/wheel) balance issue including even faulty struts. It is also possible for the vibration to...

It sounds like this may be related to a faulty throttle position sensor or potentially a dirty or failing mass air flow sensor. The mass air flow sensor monitors air intake as it is mixed with fuel prior to being...

The preferred camber setting in the rear for the 1998 Mirage is -0.69 degrees. However, camber in the rear on this vehicle can be in the range of -1.19 to -.19 and still be acceptable. If your camber setting is...

Hi there: To be completely honest, there could be multiple issues with your 2008 Mercedes-Benz that are causing the symptoms you're describing, ranging from something simple like a crankshaft position sensor to the throttle position sensor or complex issues with...

Unfortunately, we cannot speak for auto part suppliers so I can only make suggestions. If this gasket you are looking for is not a commonly replaced item, that may be the reason your search is so difficult. Most suppliers will...

Hi. The wires behind the dash may be related, but probably not. The vehicle should be checked for proper spark and fuel delivery when it is acting up. This can be done using a fuel pressure gauge to check for...

Hello. You will need all of the bolts for the intake manifold, intake manifold gaskets, and starter bolts. The bolts must be replaced because they are made from aluminum, and are designed for one-time use. Gaskets should always be replaced...

While it’s important to wear your seat belt and have your seat back in the proper position, it’s just as important to sit in the right position while driving or riding. Sit upright, completely against the back of the...