Popular questions

Hi there: Front end suspension components are impacted more than any other mechanical part in regards to driving conditions. If a vehicle is subject to frequent off road use, road damage or frequent curb strikes, the front end parts like...

Hello. A misfire under load is typically caused by a problem in the secondary ignition system (i.e. plugs, wires, coil pack). This will also cause your Check Engine Light to flash. The powertrain control module (PCM) directly controls coil operation,...

I am not 100 percent sure that our mobile mechanics are able to provide this service on your Scion. In order to receive a quote, you need to request a spark plug replacement service by clicking this link. Once we...

You may have a restriction in your radiator or condenser that is preventing the cooling of the respective fluids that go through these parts. Restrictions will cause hot spots and therefore will not allow sufficient cooling of the refrigerant or...

Hello - the P0824 code is an error with the shift selector mechanism, failing to detect the shifter forward/backward positioning. This problem will require specialized equipment and parts from your manufacturer. Contact your vehicles dealer service center for assistance. ...

In order for the EVAP system to complete the drive test you need to be at a cruise steady speed with engine warm and no check engine light on. The actual speed is needed will be in overdrive above 45...

You will need to do some further testing to figure out where the issue is. This is going to require you trace the power supply from the brake pedal to the bulb. All of the following can be the cause...

Your car has an electronically controlled transmission, so whatever occurred will have left traces in the form of trouble codes in the transmission control module. These codes can be read and interpreted by a technician with the appropriate equipment. The...

The excessive pressure causing the hoses to blow off suggests that your cooling system is not flowing properly and that there is a back up of some kind somewhere in the system. This is generally caused by a faulty thermostat...

Hi there. If the battery is fine, then it may be a bad battery cable, starter, or even the security system. I usually try a spare key if there is one and also try starting it in neutral to make...

I am not sure what the white power is but suspect it was from the chemicals used to clean the engine has caused some sort of chemical reaction on the metal parts of engine. I recommend having the engine cleaned...

Claimed by Kevin Gainer

Your a/c should of cycled out at 24 psi on the low side and you should not let it get to zero. The a/c cycling switch will need to be replaced first then the system rechecked. You will find the...

If you have low oil pressure indication and getting engine noise then the oil pump is most likely the cause and not the oil sending unit. In order to verify the cause the oil pressure would need to be checked...

Hello. There are a lot of things that can cause this on your vehicle. I would usually start by scanning the computer for any codes. If there are codes set it can help to find the issue. If there are...

Hi there. A car that is difficult to start in the morning can be caused by a battery that is losing cold cranking amps, a faulty starter solenoid, distributor or ignition coils that are worn out, or fuel system components...

With the floor board getting hot during the drive, you may want to look underneath the truck and see if the catalytic convertor is located roughly in the area where the heat is coming from. It sounds to me like...

Hi there. Check the camshaft position sensor and see if it has failed. Usually the engine will start and run with a partial failed camshaft sensor, however, when the sensor has failed completely and lost communication to the computer, then...

Hi there. The message could have came on for something that may have been active on the engine or transmission. If the light comes on again, then the computer (ECM) should store the events and you could have them read...

The cooling fan and thermostat would need to be checked for operation first. Also, the system pressure should be checked and tested for leaks. I recommend having a mechanic, such as one from YourMechanic, come out to you and inspect...

Hello. If this message is coming on then the computer is detecting that the engine is overheating. I would check the coolant level first. If it is low then there is a coolant loss issue. If the level is fine...

Hi there. Sounds like you might be having an internal transmission issue. Automatic transmissions have many sensors and solenoids as well as valves, bands and clutches that are responsible for proper operation. Transmissions can set codes just like the engine,...

Hello and thank you for contacting YourMechanic. The fault for the car access system is displayed from the Control Module Car Access (CAS). The CAS is located under the dash by the steering column. Disconnect the battery ground to the...