Popular questions

Hi there. Check the harness wires from the transfer case to the output shaft speed sensor. See if the speed sensor wires are burned and shorted into the harness. This could cause the 4wd to engage when ever and at...

The short answer is no. The harmonic balancer is manufactured in three pieces: The hub, a rubber sleeve, and the outer sleeve. They are held together with adhesive and the reason your's fell apart is because the rubber has gotten...

Hi Valerie. We'd be happy to come to your location to replace your alternator on the Chrysler 200 and you can request an estimate by clicking this link. However, I'm not 100% certain that is the source of your error...

The majority of the top end of the motor will in fact need to come apart in order to replace head gaskets. However, this would not necessarily be true for replacing only the timing belt.

A good strategy is to research used parts availability and pricing, in your locale at Car-Part.com. Once you have selected the parts you desire to replace, a certified Mechanic from YourMechanic can assist with the installation. With regard to the...

An erratic fuel pump may be one of a few different problems. You need to check to see if the fuel pump is getting power when the problem is happening. If it is, then the ground in the right rear...

Hello. It sounds like the spark plugs are fouled and the spark plug wires need to be replaced. It is possible that the fuel filter is clogged up and needs to be replaced as well. Have a certified technician, like...

Hi. First off, a leaking brake line is very unsafe because only half of your brake system is engaging when you use your brakes. From my experience, you have worn out the brakes that only work when you have a...

Hello. A common problem for your vehicle is the lights staying on due to a brake switch malfunction. The switch tells the car when to turn on the brake lights and when to turn them off. In most cases, the...

Hi There, It sounds like you are describing the symptoms of a failing throttle position sensor. The throttle position sensor monitors the throttle position of the throttle plate inside the throttle body in relation to your foot position on the...

Check the drive belt to the vehicle and see if its cracked or glazed. A cracked or glazed drive belt will squeal when under a load. Also, check the pulleys and see if the bearings are going out. A drive...

Hello. A transmission replacement for that model of vehicle will likely cost a few thousand dollars, including the cost of labor to install it. At the moment YourMechanic, does not currently offer engine or transmission mechanical services. For a repair...

Hello. I have seen this quite often on this vehicle. The problem is typically always the window motor. The motor fails and will not longer be able to move the window up or down. I typically start by removing the...

The most common for the clutch to be hard to push and is real noisey is going to be a broken clutch pressure plate. You will need to replace the clutch assembly to fix the problem.

Your best option is to buy a service manual; it will detail the steps required to replace the TCC solenoids. Unfortunately, YourMechanic does not work on transmissions so it may be necessary to take the car to a transmission shop,...

Hello. It sounds like the sonar system is malfunctioning and you have some sonar system sensors that are not working properly. The sonar system should be diagnosed so that the proper sensor can be replaced. Once the sonar system has...

The brake light switch should be checked for proper operation since it's the most common failure for this issue. The the brake light system needs to be checked for a switch failure and to see if water is getting into...

Hi there. Changing from a gasoline powered vehicle to diesel would require a complete rebuild of virtually your entire powertrain; including engine, fuel system, ignition system, computer, sensors and fuel distribution network of lines and the tank. It's not worth...

Claimed by Kevin Gainer

If the alternator is "new", and thus presumably good, the vehicle engine is running, the alternator drive belt is appropriately tightened, and yet you are not getting around 14.5 volts of charging current at the battery posts, that means there...

You should first check the bulb by swapping bulbs from one side to the other to see if you have a defective bulb. If swapping bulbs do not work then you need to check light socket wires are getting power...

It is very possible that the quality control of those particular parts may not be what it used to be. It just depends on how many times you've had to replace it. Sometimes Parts can last for years and other...