Popular questions

If the coolant level keeps dropping there is either an internal or external leak. Leaks are typically found by simple pressure testing of the cooling system. Engine coolant can leak externally through a hose, radiator, water pump, etc. or internally...

A high idle upon cold start is generally normal for any vehicle as this is part of the cold start enrichment process as the engine warms up. As a general rule, car engines do not like cold weather and do...

In some cases, an OBD-II code like you've described can be triggered by the electrical harness attached to a sensor. So, it's possible that the reason you're having this idle problem is due to the harness being faulty as opposed...

This is normal when the AC is on. The air conditioning compressor requires torque from the belt system on the engine to power it. When the AC is off, the compressor clutch does not activate, meaning the AC is not...

Considering that all those parts were just replaced I would recommend retracing your steps to determine if any loose connections exist anywhere. If the battery connections are loose this can cause the vehicle to make a click sound but not...

There seems to be a combination of problems going on with your vehicle. First thing to address is whether you want to keep the aftermarket remote start. If not, the ignition switch system needs to be restored. Bypassing the remote...

Whether the check engine light illuminated due to pulling the fuse you refer to will not be known until a mechanic can perform a check engine light diagnostic. During such a diagnostic, a certified mechanic from YourMechanic would use a...

Hi there - sorry to be the bearer of bad news, but it sounds like the timing belt has possibly jumped a cog or three, or somehow the camshaft timing was somehow set incorrectly. If the timing belt tensioner was...

Hi there. Check the ignition system to see if the spark plugs have wet fuel on them. If they have fuel on them, then check to see if the spark plug wires are good and have any burn spots. Check...

There should be an emissions control label in the under hood area with a diagram showing the two connections. Sometimes it is on the underside of the hood. If there is no label, when the pump is powered on, simply...

I would first verify that the vehicle has a drain above 200 milliamps by disconnecting the battery's negative cable and putting an amp tester between the post and clamp. The test should be done correctly by having the tester...

Hi there. It is more than likely that you have either a damaged CV joint or axle, especially if you hit a curb. If you are going to remove everything, I would recommend inspecting the inner CV axle shaft input...

This could be caused by a loose lower cover plate. Trucks have a metal plate that protects the underside of the engine from debris. This plate is often removed for repairs and sometimes not all the bolts will be present...

Hello. From what you describe it would appear that your Check Engine Light is on for the intake manifold position sensor. Your vehicle is equipped with an intake manifold that uses butterfly valves inside the manifold ports in order to...

Unfortunately, without physically seeing the ignition cylinder in person, it would be difficult to determine why it is unable to go back in. One thing you can attempt to do is to take your Dodge's ignition cylinder to a...

While it may feel that Honda may be the culprit, I have seen this issue not only with them but also with other models throughout my career, and I have witnessed the frustration my customers have experienced first hand. I...

From your explanation of the situation, it sounds to me like your vehicle may need a new clutch. If you are in gear and the vehicle struggles to move and the engine speed increases, the transmission is slipping. A failure...

This may suggest the transmission synchros may be wearing out. Your transmission has small gear synchronizer rings that help to move the transmission in and out of the various gears. When these begin to wear out, you may notice a...

First of all, I don't see that your vehicle is equipped with an inertia switch. Secondly, even if it were, it would not cause the problem you are having. A tripped inertia switch would prevent power from getting the fuel...

Hi there. What you are describing is commonly associated with an internal problem in the throttle body or a vacuum leak. However, it is also possible that you have a problem with air fuel ratio sensors or ECM is sending...

Your car’s Intelligent Key™ allows you to start the car without the need for a physical key. However, the system isn’t foolproof. It requires that your Intelligent Key™ be programmed and have a good battery. The Intelligent Key™ insertion indicator...

The coolant temperature sensor is likely what caused your Check Engine light. Sometimes aftermarket manufacturers produce parts of a lesser quality than the OEM. However, this does not mean that all aftermarket manufacturers produce faulty parts. It is harder to...