Q: Wheres the crankshaft sensor located on a 2010 vw cc 2.0

asked by on March 31, 2017

Where is the cranshaft sensor located?
My car has an automatic transmission.

Crankshaft Position Sensor Replacement $105.83 - $832.44 Get a Quote

Hi There, The crankshaft position sensor on your vehicle should be located behind the timing chain cover. In order to get to it, you will need to remove the top plastic cover and then the timing cover itself. It should be fitted inside the housing with some wires plugged into it.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing


Experienced Mechanic?

Earn up to $70/hr

What others are asking

My car acelerates on it on and when I try to stop it seems as it try to take off making my car jerk really hard. I just replaced m

In addition to seeking a diagnostic and repair, you can report unintended acceleration incidents to the National Highway Traffic Safety Administration - NHTSA. Obviously, uncommanded acceleration is a serious safety hazard. Without a first hand examination of your car, it...

Truck stalls when shifting into drive from park or reverse

Hi there. The vehicle running great, once past the initial stall, leads me away from a fuel delivery concern. The stalling issue may be, the minimum airflow rate is not properly set. This could be the result of a dirty...

Do I need to change spark plugs if over time limit but well under miles limit?

Hi there. As long as the vehicle is performing normally and no Check Engine Lights are on, you should be fine until reaching the 105,000 mile mark. When it is time to change them, you may want to consider having...

Truck is running rough, loses power, backfiring noise - 1994 Nissan D21

Hey there. I would check fuel pump output and condition of fuel injectors (flow rate and solenoid resistance). After that, I would evaluate the ignition system, including distributor, plug wires, timing. If you would like to have this checked for...

White smoke from the engine and smells of rubber with the knocking sound

My guess is that you have a leak somewhere, most likely a coolant leak. Coolant leaking onto a hot engine will immediately result in white smoke. Since you stopped the vehicle before all of the coolant was lost, the vehicle...

My car makes a clunk noise when turning the wheel while parked

Normally, the noise you are describing is commonly seen with failed outer tie rods, failed CV axles, broken sway bar bushings and the steering linkage itself. With the modification of the vehicle, it can change the operation of components as...

How do I add washer fluid to a 2012 Chevrolet Cruze?

Washer fluid helps keep your windshield clean, and your visibility high. Adding more washer fluid is very easy: Open the hood of your vehicle. Release the washer cap. Add washer fluid to the washer fluid basin.

Related articles

Can a Bad Sensor Prevent a Car From Starting?
If your car isn't starting or has a hard time starting, a faulty sensor may be to blame. Car sensors monitor data to keep your car running smoothly.
The Most Common Error Codes for Transmission Problems
If your Check Engine Light has come on, there are a number of conditions that could be causing it. Many are related...
How Long Does a Speedometer Sensor Last?
While While a mechanical speedometer will use a speedometer cable attached to the driveshaft and transmission, that’s not the case with an electronic speedometer, such as is used in most modern vehicles. These use a speedometer sensor. It’s mounted to...