Q: WHERE IS THE CRANKSHAFT POSITION SENSOR ON THE 2004 BMW 745LI?

asked by on July 15, 2017

I NEED TO REPLACE THE CRANKSHAFT POSITION SENSOR BUT CAN'T LOCATE IT. ANY HELP WOULD BE GREATLY APPRECIATED.

My car has 166000 miles.
My car has an automatic transmission.

The crankshaft sensor is located on bottom right of transmission bell housing.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing


Experienced Mechanic?

Earn up to $70/hr

What others are asking

Wobble in front end
There are a few things that may be worn in the steering system. The most common would be the Pitman and Idler arms. These components ensure that both front wheels turn as the steering wheel is turned. If these components...
How to clean carbon buildup on a 2015 Eco Boost Mustang
It's easy, your catch can isn't going to stop it, so when you put that on you don't have to worry. But to clean it now, all you have to do is take off any big vacuum on the intake...
I need some answers in order to get my permit. please help
Hello. Let's get these questions answered for you. All vehicles should be serviced per the manufacturers maintenance schedule (https://www.yourmechanic.com/article/how-to-maintain-your-car-on-a-schedule-by-brent-minderler). The owners manual contains this schedule that is set up to best maintain the service of any vehicle. There is no...
At 70 mph, braking in rain, car pulls hard to the right
Hey there, thanks for writing in about your 2004 Jaguar XJ8. If you have any kind or even a little brake pulsation in the brakes when you stop, this may cause a wheel to momentary stop in wet weather when...
Help with my truck's rpm's being too low and won't stay running.
Hi there. It seems that there is a vacuum leak on your engine. Check all of the vacuum lines and the vacuum brake booster for any cracks or breaks on the lines and hoses. Replace any hoses or lines that...
Ford F150 burglar alarm goes off for no reason
Factory- installed and aftermarket alarm systems function in a similar manner. Factory systems may be easier to diagnose because often, the system is accessible with the proper scan and diagnostic tools. Almost like a fault code for engine performance can...
clicking noise when turn signal is off
Hi there. If you are hearing a repetitive clicking sound, it is possible that it's coming from the engine compartment. In some cases, this can be caused by a loose serpentine or drive belt or pulley, a timing belt that...
I have a 2006 Jeep Commander and I just realized something leaking on my passenger side floor board and my car runs hot.
Hi Donna. Thanks for contacting us today. What you are describing is typically caused by a heater core that is damaged or a supply line that has ruptured or has a progressive leak. Either way, this would be a source...
Do I need alignment after replacing front shocks and struts
Some vehicles have fixed front camber which is typically the only alignment criteria (measure) that would be affected by strut replacement. However, your vehicle does have adjustable camber settings and so, yes, the vehicle would have to be aligned if...

Related articles

Symptoms of a Bad or Failing Throttle Body Temp Sensor
Common signs include poor engine performance, stalling, and broken electrical connections.
Symptoms of a Bad or Failing Throttle/Accelerator Pedal Position Sensor
Common signs of a faulty pedal position sensor include inconsistent engine response, reduced fuel efficiency, and the Check Engine Light coming on.
How to Replace a Car Battery Temperature Sensor
The battery has a battery temperature sensor that can fail if the Check Engine Light comes on, the battery voltage is low, or the RPM curve surges.