Q: What does the small light indicator mean?

I would not want to condemn your transmission without having a mechanic first going through some preliminary checks of the noises from the transmission (https://www.yourmechanic.com/services/grinding-sound-from-transmission-inspection). First, I would verify your complaint. Then I would sample the fluid for proper level...

Hi. If the vehicle was starting before you replaced the ignition switch then the switch may be defective or the switch may not be lined up properly. It is not uncommon for the security system to act up after an...

The amount of amperage it takes to start a car is high and if the jumper cables are any smaller than 10 or 8 gauge they will heat up thats pretty normal. If the car isn't cranking at all I...

Im sorry to tell you that the bearing housing is not generally replaceable. Once it's damaged or dented, it's nearly impossible to fix. You can check with a local rear end builder or hot rod shop to see if they...

You probably have a bad crankshaft sensor (https://www.yourmechanic.com/services/crankshaft-position-sensor-replacement). If the computer does not read a signal from the crank sensor when trying to start the car, it does not send power to the fuel pump or ignition coil. A certified...

If all of these issues began at the same time, it is possible that you have a bad ignition switch (https://www.yourmechanic.com/services/ignition-switch-replacement). Heat, Air Conditioning and I believe the radio are only powered with the key in the ON position. They...

Hi there, thanks for writing in. This is a known problem, and Chrysler has a recall (https://www.yourmechanic.com/article/what-to-do-if-your-car-is-recalled-by-jason-unrau) (06V432000) to correct it. Contact your Chrysler dealer as soon as possible to have this problem corrected.

Hi there: Before you have one of our mobile mechanics replace the crankshaft position sensor, you should have them complete a full check engine light inspection (https://www.yourmechanic.com/services/check-engine-light-is-on-inspection) first. It's possible that the code being displayed on your code reader is...

Hello. When you get this code it is because the computer is seeing that the valve timing is off. Most of the time this is a timing solenoid issue. It can also be caused by low engine oil, a sensor...