Q: Vehicle does not start.

Hello. There are many components that can fail and cause an internal engine noise. On your car the most common is either a failure in the camshaft, this would cause a loud ticking, or a rod bearing which would cause...

If you are getting overheating only at lower engine speeds with no obvious reasons, then you will need to check if there is good flow through the radiator using a laser temperature sensor. By doing this you will be able...

Hey there, thanks for writing in about your 2005 Dodge Ram 1500. Your symptoms sound very similar to a vehicle with a faulty engine position sensor. Typically the crankshaft position sensor (https://www.yourmechanic.com/services/crankshaft-position-sensor-replacement) will fail before the camshaft position sensor (https://www.yourmechanic.com/services/camshaft-position-sensor-replacement)...

Hello there, the battery light on your 2004 Toyota Tundra is there to warn you that the alternator output is out of specifications. If the alternator output is to low or high, the light will be on. The alternator output...

When I look up the strut assemblies parts on this vehicle the left and right struts use the same part number. They are the same.

Hello, This may be a result of low transmission fluid (https://www.yourmechanic.com/services/transmission-fluid-service) or potentially a faulty transmission control module. A faulty transmission control module may cause a delay in acceleration or erratic shifting of gears. The transmission control module has various...

Hello. A misfire can be caused by a number of things. Depending on what they found to be the problem it is quite possible that this is an accurate estimate. Most of the time this is caused by a failure...

Hello - the combination of a lack of power from a standing start, and a poor shifting complaint may indicate your transmission is in "limp mode". This would cause it to take off in 2nd or even 3rd gear -...

Hello, thank you for writing in. The best thing you can do is make traction (https://www.yourmechanic.com/services/traction-control-switch-replacement). You need to use dirt, leaves, kitty litter, old carpeting, a floor mat, or other flat objects to stick under the tires to get...