Skip the auto shop - Our mechanics make house calls

Q: Rumbling noise when shifting into reverse

asked by on

There's a rumbling noise when I shift into reverse (only reverse). What is causing this?

There is a technical service bulletin (TSB) that may address your concern. It is # TSB2735R and it states that the automatic transmission control cable assembly can cause a rattle noise in reverse. The fix is to secure the cable with a zip tie. I suggest you have a trained professional, such as one from YourMechanic, inspect your vehicle’s noise firsthand to determine if the TSB applies.

Was this answer helpful?

Need advice from certified mechanic? Get help now!

Over 1000 mechanics are ready to answer your question.
The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Ask a Mechanic
(100% Free)

Have a car question? Get free advice from our top-rated mechanics.

Ask A Mechanic
Over 10,000 questions answered!

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing

Get a quote

What others are asking

Q: car starts sometimes and just shuts off

Hi there. Assuming, the engine ran fine prior to the repairs being performed, leads me to believe the crankshaft and camshaft were not properly aligned when the timing belt was installed. As this engine is identified as an interference engine,...

Q: does flushing your coolant system fix mixed fluid buildup?

Hi there. You may have to flush the engine a few times and then run fresh water a couple times until system is clean. Then refill it with the proper coolant and distilled water in a 50/50 mixture. If you...

Q: There is an awful clunking rattling noise when the engine is running.

Hi there. There could be either the engine is having a bearing slap on the rod bearings with too much wear causing the noise or an accessory on the engine is locking up making the belt tensioner pop back and...

Related articles

P2428 OBD-II Trouble Code: Exhaust Gas Temperature Too High Bank 1
P2428 code definition A P2428 trouble code signifies that the PCM has detected a problem in the exhaust gas temperature sensor circuit in bank 1, which subsequently contains the number one...
How Much Does a Mechanic Make in Vermont?
Automotive technician jobs in Vermont have an average mechanic salary of $37k, with some mechanics earning a salary of $53k.
P2103 OBD-II Trouble Code: Throttle Actuator Control Motor Circuit High
P2103 means there is a fault with the throttle actuator control motor circuit, likely due to a defective electrical component or part.